From: Vladislav Leonov <vlad@zlab.su>
To: linux-rockchip@lists.infradead.org
Cc: linux-arm-kernel@lists.infradead.org,
Simon Glass <sjg@chromium.org>,
linux-clk@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org, Vladislav Leonov <vlad@zlab.su>,
Conor Dooley <conor+dt@kernel.org>,
Heiko Stuebner <heiko@sntech.de>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Rob Herring <robh@kernel.org>
Subject: [PATCH 06/25] ARM: dts: rockchip: Add Ethernet GMAC node for RV1106
Date: Mon, 10 Aug 2026 15:10:57 +0300 [thread overview]
Message-ID: <20260810121121.210040-7-vlad@zlab.su> (raw)
In-Reply-To: <20260810121121.210040-1-vlad@zlab.su>
Rockchip RV1106 has GMAC 10/100 ethernet controller.
Signed-off-by: Vladislav Leonov <vlad@zlab.su>
---
arch/arm/boot/dts/rockchip/rv1106.dtsi | 62 ++++++++++++++++++++++++++
1 file changed, 62 insertions(+)
diff --git a/arch/arm/boot/dts/rockchip/rv1106.dtsi b/arch/arm/boot/dts/rockchip/rv1106.dtsi
index fa5d0d7f4dcb..71dd3dcc386c 100644
--- a/arch/arm/boot/dts/rockchip/rv1106.dtsi
+++ b/arch/arm/boot/dts/rockchip/rv1106.dtsi
@@ -19,6 +19,7 @@ / {
interrupt-parent = <&gic>;
aliases {
+ ethernet0 = &gmac;
gpio0 = &gpio0;
gpio1 = &gpio1;
gpio2 = &gpio2;
@@ -282,6 +283,67 @@ system_sram: sram@ff6c0000 {
ranges = <0 0xff6c0000 0x40000>;
};
+ gmac: ethernet@ffa80000 {
+ compatible = "rockchip,rv1106-gmac", "snps,dwmac-4.20a";
+ reg = <0xffa80000 0x10000>;
+ interrupts = <GIC_SPI 93 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 96 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "macirq", "eth_wake_irq";
+ rockchip,grf = <&grf>;
+ clocks = <&cru CLK_GMAC0_TX_50M_O>, <&cru CLK_GMAC0_REF_50M>,
+ <&cru ACLK_MAC>, <&cru PCLK_MAC>;
+ clock-names = "stmmaceth", "clk_mac_ref",
+ "aclk_mac", "pclk_mac";
+ resets = <&cru SRST_A_MAC>;
+ reset-names = "stmmaceth";
+
+ snps,mixed-burst;
+ snps,tso;
+
+ snps,axi-config = <&stmmac_axi_setup>;
+ snps,mtl-rx-config = <&mtl_rx_setup>;
+ snps,mtl-tx-config = <&mtl_tx_setup>;
+
+ phy-mode = "rmii";
+ clock_in_out = "input";
+ phy-handle = <&rmii_phy>;
+
+ status = "disabled";
+
+ mdio: mdio {
+ compatible = "snps,dwmac-mdio";
+ #address-cells = <0x1>;
+ #size-cells = <0x0>;
+ rmii_phy: ethernet-phy@2 {
+ compatible = "ethernet-phy-ieee802.3-c22";
+ reg = <2>;
+ clocks = <&cru CLK_MACPHY>;
+ resets = <&cru SRST_MACPHY>;
+ phy-is-integrated;
+ };
+ };
+
+ stmmac_axi_setup: stmmac-axi-config {
+ snps,wr_osr_lmt = <4>;
+ snps,rd_osr_lmt = <8>;
+ snps,blen = <0 0 0 0 16 8 4>;
+ };
+
+ mtl_rx_setup: rx-queues-config {
+ snps,rx-queues-to-use = <1>;
+ queue0 {
+ status = "okay";
+ };
+ };
+
+ mtl_tx_setup: tx-queues-config {
+ snps,tx-queues-to-use = <1>;
+ queue0 {
+ status = "okay";
+ };
+ };
+ };
+
emmc: mmc@ffa90000 {
compatible = "rockchip,rv1106-dw-mshc", "rockchip,rk3288-dw-mshc";
reg = <0xffa90000 0x4000>;
--
2.47.3
next prev parent reply other threads:[~2026-08-10 12:16 UTC|newest]
Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-10 12:10 [PATCH 00/25] ARM: rockchip: Add peripheral support for RV1106 Vladislav Leonov
2026-08-10 12:10 ` [PATCH 01/25] dt-bindings: reset: Add RV1106 CRU reset definitions Vladislav Leonov
2026-08-10 12:10 ` [PATCH 02/25] clk: rockchip: Add reset controller support for RV1106 Vladislav Leonov
2026-08-10 12:10 ` [PATCH 03/25] ARM: dts: rockchip: Add reset bindings to RV1106 Vladislav Leonov
2026-08-10 12:10 ` [PATCH 04/25] dt-bindings: net: rockchip-dwmac: add RV1106 compatible Vladislav Leonov
2026-08-10 12:10 ` [PATCH 05/25] net: ethernet: stmicro: stmmac: dwmac-rk: Add RV1106 support Vladislav Leonov
2026-08-10 12:10 ` Vladislav Leonov [this message]
2026-08-10 12:10 ` [PATCH 07/25] dt-bindings: phy: rockchip,inno-usb2phy: Add RV1106 compatible Vladislav Leonov
2026-08-10 12:10 ` [PATCH 08/25] phy: rockchip: inno-usb2: Add support for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 09/25] dt-bindings: usb: rockchip,dwc3: add RV1106 SoC support Vladislav Leonov
2026-08-10 12:11 ` [PATCH 10/25] ARM: dts: rockchip: Add USB2 PHY and USB3-OTG (DWC3) nodes for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 11/25] dt-bindings: i2c: rk3x: Add RV1106 compatible Vladislav Leonov
2026-08-10 12:11 ` [PATCH 12/25] ARM: dts: rockchip: Add I2C nodes for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 13/25] ARM: dts: rockchip: Add DMAC node " Vladislav Leonov
2026-08-10 12:11 ` [PATCH 14/25] ARM: dts: rockchip: Add DMA support to UART nodes Vladislav Leonov
2026-08-10 12:11 ` [PATCH 15/25] dt-bindings: clock: rockchip: Add SCLK_IN_SPI1 for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 16/25] clk: rockchip: Add SCLK_IN_SPI1 gate " Vladislav Leonov
2026-08-10 12:11 ` [PATCH 17/25] dt-bindings: spi: rockchip: Add RV1106 compatible Vladislav Leonov
2026-08-10 12:25 ` Mark Brown
2026-08-10 12:11 ` [PATCH 18/25] spi: rockchip: Add support for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 19/25] ARM: dts: rockchip: Add SPI nodes " Vladislav Leonov
2026-08-10 12:11 ` [PATCH 20/25] dt-bindings: rng: rockchip: Add RV1106 compatible Vladislav Leonov
2026-08-10 12:11 ` [PATCH 21/25] ARM: dts: rockchip: Add RNG node for RV1106 Vladislav Leonov
2026-08-10 12:11 ` [PATCH 22/25] ARM: dts: rockchip: Add SDMMC1 " Vladislav Leonov
2026-08-10 12:11 ` [PATCH 23/25] ARM: dts: rockchip: add arm,cpu-registers-not-fw-configured to RV1106 timer node Vladislav Leonov
2026-08-10 12:11 ` [PATCH 24/25] dt-bindings: pwm: rockchip: Add RV1106 compatible Vladislav Leonov
2026-08-10 12:11 ` [PATCH 25/25] ARM: dts: rockchip: Add PWM nodes for RV1106 Vladislav Leonov
2026-08-10 18:35 ` [PATCH 00/25] ARM: rockchip: Add peripheral support " Jakub Kicinski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260810121121.210040-7-vlad@zlab.su \
--to=vlad@zlab.su \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=heiko@sntech.de \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=robh@kernel.org \
--cc=sjg@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox