[PATCH] pinctrl: meson: sync some modify from A4

[PATCH] pinctrl: meson: sync some modify from A4

[Xianwei Zhao via B4 Relay]

From: Xianwei Zhao <xianwei.zhao@amlogic.com>

Set the drive strength before enabling the output to avoid enabling
the output with an unintended drive strength.

Also return the actual output enable state from
PIN_CONFIG_OUTPUT_ENABLE instead of always reporting it as enabled.

Signed-off-by: Xianwei Zhao <xianwei.zhao@amlogic.com>
---
Sync some fixes from  A4.
---
 drivers/pinctrl/meson/pinctrl-meson.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index 4507dc8b5563..1eea3e9d1cb2 100644
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -252,11 +252,11 @@ static int meson_pinconf_set_output_drive(struct meson_pinctrl *pc,
 {
 	int ret;
 
-	ret = meson_pinconf_set_output(pc, pin, true);
+	ret = meson_pinconf_set_drive(pc, pin, high);
 	if (ret)
 		return ret;
 
-	return meson_pinconf_set_drive(pc, pin, high);
+	return meson_pinconf_set_output(pc, pin, true);
 }
 
 static int meson_pinconf_disable_bias(struct meson_pinctrl *pc,
@@ -498,9 +498,9 @@ static int meson_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin,
 		break;
 	case PIN_CONFIG_OUTPUT_ENABLE:
 		ret = meson_pinconf_get_output(pc, pin);
-		if (ret <= 0)
+		if (ret < 0)
 			return -EINVAL;
-		arg = 1;
+		arg = ret;
 		break;
 	case PIN_CONFIG_LEVEL:
 		ret = meson_pinconf_get_output(pc, pin);

---
base-commit: 761af93c9f1a100b8d9f71aa744b8f9abbbbbfb2
change-id: 20260812-sync_a4-011ae20ff31c

Best regards,
-- 
Xianwei Zhao <xianwei.zhao@amlogic.com>