From: Navid Ghahremani <ghahramani.navid@gmail.com>
To: Krzysztof Kozlowski <krzk@kernel.org>
Cc: "Navid Ghahremani" <ghahramani.navid@gmail.com>,
"Rob Herring" <robh@kernel.org>,
"Conor Dooley" <conor+dt@kernel.org>,
devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
"Arnd Bergmann" <arnd@arndb.de>,
"Stefan Dösinger" <stefandoesinger@gmail.com>
Subject: Re: [PATCH 01/24] dt-bindings: cache: l2c2x0: Describe ZTE device-read serialization
Date: Wed, 14 Oct 2026 08:08:17 +0100 [thread overview]
Message-ID: <20261014070817.1718976-1-ghahramani.navid@gmail.com> (raw)
In-Reply-To: <20261012-eggplant-nyala-of-mathematics-5005e8@quoll>
Hi Krzysztof,
Thank you for the feedback and guidance.
Dropping this from DT patchwork makes complete sense for the RFC.
Based on discussions with Arnd Bergmann and Stefan Dösinger, I have
decided to decouple the contentious silicon bus/cache workaround
(patches 01, 02, and 03) completely from the mainline platform series.
For v2, I am dropping the RFC tag and submitting a clean 24-patch series
covering the core SoC platform, split CRM clock bindings/drivers,
logical reset bindings, GPIO, Generic PCIe PHY, PCIe host, MDIO,
Ethernet switch, SPI-MEM, and board DTS.
I will ensure all patches in v2 are properly routed per subsystem and
directly CC the respective subsystem maintainers as determined by
scripts/get_maintainer.pl. All DT bindings have also been verified
against dtschema and dt-doc-validate with zero warnings.
Best regards,
Navid
next prev parent reply other threads:[~2026-10-14 7:08 UTC|newest]
Thread overview: 47+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-10 12:59 [PATCH RFC 00/24] ARM: zte: Add support for Sanechips ZX279128S and ZTE ZXHN H3600 Navid Ghahremani
2026-10-10 12:59 ` [PATCH 01/24] dt-bindings: cache: l2c2x0: Describe ZTE device-read serialization Navid Ghahremani
2026-10-12 9:43 ` Krzysztof Kozlowski
2026-10-14 7:08 ` Navid Ghahremani [this message]
2026-10-10 12:59 ` [PATCH 02/24] ARM: l2c: Serialize device reads with cache maintenance when requested Navid Ghahremani
2026-10-10 14:28 ` Arnd Bergmann
2026-10-10 21:41 ` Navid Ghahremani
2026-10-11 1:02 ` Navid Ghahremani
2026-10-11 14:48 ` Arnd Bergmann
2026-10-14 7:08 ` Navid Ghahremani
2026-10-10 12:59 ` [PATCH 03/24] wifi: mt76: Serialize MMIO reads with outer cache maintenance Navid Ghahremani
2026-10-10 12:59 ` [PATCH 04/24] dt-bindings: arm: Add ZTE ZX279128S platform descriptions Navid Ghahremani
2026-10-10 12:59 ` [PATCH 05/24] ARM: zte: Add ZX279128S platform and CPU hotplug support Navid Ghahremani
2026-10-10 14:13 ` Arnd Bergmann
2026-10-10 17:34 ` Stefan Dösinger
2026-10-10 21:26 ` Navid Ghahremani
2026-10-10 12:59 ` [PATCH 06/24] dt-bindings: clock: Add ZTE ZX279128S CRM clocks and resets Navid Ghahremani
2026-10-11 9:13 ` Stefan Dösinger
2026-10-10 12:59 ` [PATCH 07/24] clk: zte: Add ZX279128S CRM clock and reset driver Navid Ghahremani
2026-10-11 11:10 ` Stefan Dösinger
2026-10-10 12:59 ` [PATCH 08/24] dt-bindings: gpio: Add ZTE ZX279128S GPIO controller Navid Ghahremani
2026-10-10 12:59 ` [PATCH 09/24] gpio: Add ZTE ZX279128S GPIO driver Navid Ghahremani
2026-10-11 11:19 ` Stefan Dösinger
2026-10-12 10:59 ` Uwe Kleine-König
2026-10-14 7:08 ` Navid Ghahremani
2026-10-10 12:59 ` [PATCH 10/24] dt-bindings: pinctrl: pinctrl-single: Add ZTE ZX279128S pin mux Navid Ghahremani
2026-10-10 12:59 ` [PATCH 11/24] dt-bindings: mfd: syscon: Add ZX279128S system controller Navid Ghahremani
2026-10-10 12:59 ` [PATCH 12/24] dt-bindings: PCI: Add ZTE ZX279128S host controller Navid Ghahremani
2026-10-10 12:59 ` [PATCH 13/24] PCI: dwc: Add ZTE ZX279128S host controller driver Navid Ghahremani
2026-10-11 13:03 ` Stefan Dösinger
2026-10-10 12:59 ` [PATCH 14/24] dt-bindings: net: Add ZTE ZX279128S MDIO controller Navid Ghahremani
2026-10-10 12:59 ` [PATCH 15/24] net: mdio: " Navid Ghahremani
2026-10-10 12:59 ` [PATCH 16/24] net: phy: Add Sanechips ZX5201 PHY support Navid Ghahremani
2026-10-10 12:59 ` [PATCH 17/24] dt-bindings: net: Add ZTE ZX279128S Ethernet switch Navid Ghahremani
2026-10-10 12:59 ` [PATCH 18/24] net: ethernet: zte: Add ZX279128S Ethernet switch driver Navid Ghahremani
2026-10-10 12:59 ` [PATCH 19/24] dt-bindings: spi: Add ZTE ZX279128S SPI flash controller Navid Ghahremani
2026-10-10 12:59 ` [PATCH 20/24] " Navid Ghahremani
2026-10-11 16:32 ` Stefan Dösinger
2026-10-14 7:07 ` Navid Ghahremani
2026-10-10 12:59 ` [PATCH 21/24] dt-bindings: usb: Add ZTE ZX279128S DWC3 controller Navid Ghahremani
2026-10-10 13:00 ` [PATCH 22/24] usb: dwc3: generic-plat: Add ZTE ZX279128S Navid Ghahremani
2026-10-10 13:00 ` [PATCH 23/24] ARM: dts: zte: Add ZX279128S SoC description Navid Ghahremani
2026-10-10 13:00 ` [PATCH 24/24] ARM: dts: zte: Add ZTE ZXHN H3600 board Navid Ghahremani
2026-10-12 19:20 ` [PATCH RFC 00/24] ARM: zte: Add support for Sanechips ZX279128S and ZTE ZXHN H3600 Stefan Dösinger
2026-10-14 7:19 ` Navid Ghahremani
2026-10-14 12:46 ` Andrew Lunn
2026-10-14 19:51 ` Stefan Dösinger
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261014070817.1718976-1-ghahramani.navid@gmail.com \
--to=ghahramani.navid@gmail.com \
--cc=arnd@arndb.de \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=krzk@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=robh@kernel.org \
--cc=stefandoesinger@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox