Re: [PATCH] clk: exynos7: Mark aclk_fsys1_200 as critical

[Sylwester Nawrocki <snawrocki@kernel.org>]

On 24.10.2020 17:43, Paweł Chmiel wrote:
> This clock must be always enabled to allow access to any registers in
> fsys1 CMU. Until proper solution based on runtime PM is applied
> (similar to what was done for Exynos5433), mark that clock as critical
> so it won't be disabled.
> 
> It was observed on Samsung Galaxy S6 device (based on Exynos7420), where
> UFS module is probed before pmic used to power that device.
> In this case defer probe was happening and that clock was disabled by
> UFS driver, causing whole boot to hang on next CMU access.
> 
> Signed-off-by: Paweł Chmiel <pawel.mikolaj.chmiel@gmail.com>
> ---
>   drivers/clk/samsung/clk-exynos7.c | 3 ++-
>   1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/clk/samsung/clk-exynos7.c b/drivers/clk/samsung/clk-exynos7.c
> index c1ff715e960c..1048d83f097b 100644
> --- a/drivers/clk/samsung/clk-exynos7.c
> +++ b/drivers/clk/samsung/clk-exynos7.c
> @@ -538,7 +538,8 @@ static const struct samsung_gate_clock top1_gate_clks[] __initconst = {
>   		ENABLE_ACLK_TOP13, 28, CLK_SET_RATE_PARENT |
>   		CLK_IS_CRITICAL, 0),

As this patch can be backported up to the commit that introduced regression
I have applied it instead of your v3, with a comment as below.

+       /*
+        * This clock is required for the CMU_FSYS1 registers access, keep it
+        * enabled permanently until proper runtime PM support is added.
+        */

>   	GATE(CLK_ACLK_FSYS1_200, "aclk_fsys1_200", "dout_aclk_fsys1_200",
> -		ENABLE_ACLK_TOP13, 24, CLK_SET_RATE_PARENT, 0),
> +		ENABLE_ACLK_TOP13, 24, CLK_SET_RATE_PARENT |
> +		CLK_IS_CRITICAL, 0),
>   
>   	GATE(CLK_SCLK_PHY_FSYS1_26M, "sclk_phy_fsys1_26m",
>   		"dout_sclk_phy_fsys1_26m", ENABLE_SCLK_TOP1_FSYS11,
  
--
Regards,
Sylwester

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel