Re: [PATCH v2] i2c/pasemi: PASemi I2C controller IRQ enablement

["Sven Peter" <sven@svenpeter.dev>]

Hi,

Looks almost good to me, just a few minor things:

On Sun, Oct 2, 2022, at 00:25, Arminder Singh wrote:
> Hello,
>
> This is v2 of the PASemi I2C controller IRQ enablement patch.

This shouldn't be inside the commit description.

>
> This patch adds IRQ support to the PASemi I2C controller driver to 
> increase the performace of I2C transactions on platforms with PASemi I2C 
> controllers. While the patch is primarily intended for Apple silicon 
> platforms, this patch should also help in enabling IRQ support for 
> older PASemi hardware as well should the need arise.

This is probably the only paragraph that should be the entire commit description.

>
> This version of the patch has been tested on an M1 Ultra Mac Studio,
> as well as an M1 MacBook Pro, and userspace launches successfully
> while using the IRQ path for I2C transactions.
>
> Tested-by: Arminder Singh <arminders208@outlook.com>

I think it's usually implied that you tested your own patches ;)

> Signed-off-by: Arminder Singh <arminders208@outlook.com>
> ---
> Changes from v1:
>  - moved completion setup from pasemi_platform_i2c_probe to
>    pasemi_i2c_common_probe to allow PASemi and Apple platforms to share
>    common completion setup code in case PASemi hardware gets IRQ support
>    added
>  - initialized the status variable in pasemi_smb_waitready when going down
>    the non-IRQ path
>  - removed an unnecessary cast of dev_id in the IRQ handler
>  - fixed alignment of struct member names in i2c-pasemi-core.h
>    (addresses Christophe's feedback in the original submission)
>  - IRQs are now disabled after the wait_for_completion_timeout call
>    instead of inside the IRQ handler
>    (prevents the IRQ from going off after the completion times out)
>  - changed the request_irq call to a devm_request_irq call to obviate
>    the need for a remove function and a free_irq call
>    (thanks to Sven for pointing this out in the original submission)
>  - added a reinit_completion call to pasemi_reset 
>    as a failsafe to prevent missed interrupts from causing the completion
>    to never complete (thanks to Arnd Bergmann for pointing this out)
>  - removed the bitmask variable in favor of just using the value
>    directly (it wasn't used anywhere else)
>
> v1 linked here: 
> https://lore.kernel.org/linux-i2c/MN2PR01MB535838492432C910F2381F929F6F9@MN2PR01MB5358.prod.exchangelabs.com/T/#m11b3504c2667517aad7521514c99ca0e07a9381f
>
> Thanks for all the feedback on the previous submission, I'm sorry
> I wasn't able to answer everyone's emails, was just pretty busy, I'll
> make sure to be more responsive this time around! Also wasn't sure whether
> the v1 changelog belonged before or after the '---' so I put it after
> to keep the commit changelog short and concise.
> (This is just one patch, didn't think it needed a cover letter)
>
>  drivers/i2c/busses/i2c-pasemi-core.c     | 29 ++++++++++++++++++++----
>  drivers/i2c/busses/i2c-pasemi-core.h     |  7 +++++-
>  drivers/i2c/busses/i2c-pasemi-platform.c |  6 +++++
>  3 files changed, 37 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-pasemi-core.c 
> b/drivers/i2c/busses/i2c-pasemi-core.c
> index 9028ffb58cc0..05af8f3575bc 100644
> --- a/drivers/i2c/busses/i2c-pasemi-core.c
> +++ b/drivers/i2c/busses/i2c-pasemi-core.c
> @@ -21,6 +21,7 @@
>  #define REG_MTXFIFO	0x00
>  #define REG_MRXFIFO	0x04
>  #define REG_SMSTA	0x14
> +#define REG_IMASK   0x18

This doesn't seem to be aligned correctly, this file seems to use a tab
to separate the register name and the offset and you used spaces here.

>  #define REG_CTL		0x1c
>  #define REG_REV		0x28
> 
> @@ -66,6 +67,7 @@ static void pasemi_reset(struct pasemi_smbus *smbus)
>  		val |= CTL_EN;
> 
>  	reg_write(smbus, REG_CTL, val);
> +	reinit_completion(&smbus->irq_completion);
>  }
> 
>  static void pasemi_smb_clear(struct pasemi_smbus *smbus)
> @@ -81,11 +83,18 @@ static int pasemi_smb_waitready(struct pasemi_smbus *smbus)
>  	int timeout = 10;
>  	unsigned int status;
> 
> -	status = reg_read(smbus, REG_SMSTA);
> -
> -	while (!(status & SMSTA_XEN) && timeout--) {
> -		msleep(1);
> +	if (smbus->use_irq) {
> +		reinit_completion(&smbus->irq_completion);
> +		reg_write(smbus, REG_IMASK, SMSTA_XEN | SMSTA_MTN);
> +		wait_for_completion_timeout(&smbus->irq_completion, msecs_to_jiffies(10));
> +		reg_write(smbus, REG_IMASK, 0);
>  		status = reg_read(smbus, REG_SMSTA);
> +	} else {
> +		status = reg_read(smbus, REG_SMSTA);
> +		while (!(status & SMSTA_XEN) && timeout--) {
> +			msleep(1);
> +			status = reg_read(smbus, REG_SMSTA);
> +		}
>  	}
> 
>  	/* Got NACK? */
> @@ -344,10 +353,14 @@ int pasemi_i2c_common_probe(struct pasemi_smbus *smbus)
> 
>  	/* set up the sysfs linkage to our parent device */
>  	smbus->adapter.dev.parent = smbus->dev;
> +	smbus->use_irq = 0;
> +	init_completion(&smbus->irq_completion);
> 
>  	if (smbus->hw_rev != PASEMI_HW_REV_PCI)
>  		smbus->hw_rev = reg_read(smbus, REG_REV);
> 
> +	reg_write(smbus, REG_IMASK, 0);
> +
>  	pasemi_reset(smbus);
> 
>  	error = devm_i2c_add_adapter(smbus->dev, &smbus->adapter);
> @@ -356,3 +369,11 @@ int pasemi_i2c_common_probe(struct pasemi_smbus *smbus)
> 
>  	return 0;
>  }
> +
> +irqreturn_t pasemi_irq_handler(int irq, void *dev_id)
> +{
> +	struct pasemi_smbus *smbus = dev_id;
> +
> +	complete(&smbus->irq_completion);
> +	return IRQ_HANDLED;
> +}
> diff --git a/drivers/i2c/busses/i2c-pasemi-core.h 
> b/drivers/i2c/busses/i2c-pasemi-core.h
> index 4655124a37f3..ba6d6ccf9cdc 100644
> --- a/drivers/i2c/busses/i2c-pasemi-core.h
> +++ b/drivers/i2c/busses/i2c-pasemi-core.h
> @@ -7,6 +7,7 @@
>  #include <linux/i2c-smbus.h>
>  #include <linux/io.h>
>  #include <linux/kernel.h>
> +#include <linux/completion.h>
> 
>  #define PASEMI_HW_REV_PCI -1
> 
> @@ -15,7 +16,11 @@ struct pasemi_smbus {
>  	struct i2c_adapter	 adapter;
>  	void __iomem		*ioaddr;
>  	unsigned int		 clk_div;
> -	int			 hw_rev;
> +	int			         hw_rev;
> +	int                  use_irq;
> +	struct completion    irq_completion;

This doesn't seem to be aligned correctly and the hw_rev line
doesn't have to be changed.

>  };
> 
>  int pasemi_i2c_common_probe(struct pasemi_smbus *smbus);
> +
> +irqreturn_t pasemi_irq_handler(int irq, void *dev_id);
> diff --git a/drivers/i2c/busses/i2c-pasemi-platform.c 
> b/drivers/i2c/busses/i2c-pasemi-platform.c
> index 88a54aaf7e3c..e35945a91dbe 100644
> --- a/drivers/i2c/busses/i2c-pasemi-platform.c
> +++ b/drivers/i2c/busses/i2c-pasemi-platform.c
> @@ -49,6 +49,7 @@ static int pasemi_platform_i2c_probe(struct 
> platform_device *pdev)
>  	struct pasemi_smbus *smbus;
>  	u32 frequency;
>  	int error;
> +	int irq_num;
> 
>  	data = devm_kzalloc(dev, sizeof(struct pasemi_platform_i2c_data),
>  			    GFP_KERNEL);
> @@ -82,6 +83,11 @@ static int pasemi_platform_i2c_probe(struct 
> platform_device *pdev)
>  	if (error)
>  		goto out_clk_disable;
> 
> +	irq_num = platform_get_irq(pdev, 0);
> +	error = devm_request_irq(smbus->dev, irq_num, pasemi_irq_handler, 0, 
> "pasemi_apple_i2c", (void *)smbus);
> +
> +	if (!error)
> +		smbus->use_irq = 1;
>  	platform_set_drvdata(pdev, data);
> 
>  	return 0;
> -- 
> 2.34.1


Best,

Sven

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel