Re: [PATCH 02/10] dt-bindings: pinctrl: Add devicetree bindings for DM816x SoC Pinctrl

["Ettore Chimenti" <ettore.chimenti@linaro.org>]

Hi Krzyszrof,

On Fri Oct 16, 2026 at 4:51 PM CEST, Krzysztof Kozlowski wrote:
> On 16/10/2026 16:41, Ettore Chimenti wrote:
>> Add devicetree bindings for TI DM816x SoC pinctrl configuration.
>> Using same definition as OMAP2/3 except pullup/down enable macros, which
>> are inverted in this SoC.
>> 
>> Signed-off-by: Ettore Chimenti <ettore.chimenti@linaro.org>
>> ---
>>  include/dt-bindings/pinctrl/dm816x.h | 20 ++++++++++++++++++++
>>  1 file changed, 20 insertions(+)
>> 
>> diff --git a/include/dt-bindings/pinctrl/dm816x.h b/include/dt-bindings/pinctrl/dm816x.h
>> new file mode 100644
>> index 000000000000..15aa15bca9bd
>> --- /dev/null
>> +++ b/include/dt-bindings/pinctrl/dm816x.h
>> @@ -0,0 +1,20 @@
>> +/* SPDX-License-Identifier: GPL-2.0-only */
>> +/*
>> + * This header provides constants specific to DM816X pinctrl bindings.
>> + */
>> +
>> +#ifndef _DT_BINDINGS_PINCTRL_DM816X_H
>> +#define _DT_BINDINGS_PINCTRL_DM816X_H
>> +
>> +#include <dt-bindings/pinctrl/omap.h>
>
> I do not see this being used here, IWYU.
>
>> +
>> +#undef PULL_UP
>> +#undef PULL_ENA
>
> Why are you undefining other macros? That's not a easy to follow code.

Do you prefer to duplicate `omap.h` defines? Only the defines above do not
apply to DM816x.

>
>
>> +
>> +/* DM81xx mux bit defines */
>> +#define PULL_ENA		(0 << 3)  /* Pullup enabled  => 0 */
>> +#define PULL_DIS		(1 << 3)  /* Pullup disabled => 1 */
>> +#define PULL_DN			(0 << 4)
>> +#define PULL_UP			(1 << 4)
>
> I do not see this used by drivers, so why do we need one more header?
> What part of SW are you binding here?
>

I added those (DN/UP) because they are not defined in `omap.h`. It may be
convenient for future board upstreaming. I can drop those if undesired.

>
> Best regards,
> Krzysztof

Best regards,
Ettore