Re: [PATCH net-next 09/12] gpio: tc956x: add TC956x/QPS615 support

[Alex Elder <elder@riscstar.com>]

On 5/2/26 10:42 PM, Julian Braha wrote:
> On 5/1/26 16:54, Alex Elder wrote:
>> +config GPIO_TC956X
>> +	tristate "Toshiba TC956X GPIO support"
>> +	depends on TOSHIBA_TC956X_PCI
>> +	default m if TOSHIBA_TC956X_PCI
> 
> Hi Alex,
> 
> In your Kconfig changes, this condition 'if TOSHIBA_TC956X_PCI' is dead
> code. Since you have the dependency on TOSHIBA_TC956X_PCI, you can just
> make the 'default m' unconditional - assuming this is what you intended.

I'm not sure I'd call it "dead" but you're right, it's not
necessary because it already depends on that symbol.

> Perhaps you would prefer to use 'default TOSHIBA_TC956X_PCI', which
> would have GPIO_TC956X default to 'm' or 'y' when TOSHIBA_TC956X_PCI is
> 'm' or 'y', respectively.

Yeah that might be better.  I'd like to eventually include
COMPILE_TEST as well, and that might need the "if" on the
default.  I'll find out whenever I test that.

This GPIO feature should still be a module even if
TOSHIBA_TC956X_PCI is y, because it's not always
necessary to enable the GPIO driver (depending on
how devicetree defines the PHY resets).

So:  In drivers/gpio/Kconfig it will be "default m", and
for drivers/net/ethernet/stmicro/stmmac/Kconfig it will be
default TOSHIBA_TC956X_PCI (at least for now).

Thanks a lot for the suggestion.

					-Alex

> - Julian Braha