[PATCH] spi: imx: fix slab corruption from undersized DMA bounce buffers

[PATCH] spi: imx: fix slab corruption from undersized DMA bounce buffers

[Richard Leitner]

Since commit faa8e404ad8e ("spi: imx: support dynamic burst length for
ECSPI DMA mode"), the driver allocates its private DMA TX/RX buffers
with kzalloc(dma_len), where dma_len is only rounded up to 4 bytes, but
maps, syncs and unmaps them with DMA_CACHE_ALIGNED_LEN(dma_len), i.e.
rounded up to the cache line size. As a result, the DMA API operates on
memory beyond the end of the allocation.

This was observed on a custom i.MX8MP platform with an mcp251xfd CAN
controller under heavy RPMSG load, as a series of refcount_t warnings
triggered from rpmsg_recv_done() in virtio_rpmsg_bus:

  refcount_t: addition on 0; use-after-free.
  refcount_t: underflow; use-after-free.
  refcount_t: saturated; leaking memory.

Leading finally to an "Unable to handle kernel paging request" oops.
Reproducing this problem took between 30 minutes and roughly 30 hours
under the same workload.

Hardware watchpoints on the refcount of a struct rpmsg_endpoint showed
it was overwritten from 2 to 1 by __pi_memcpy_generic() in the
irq/155-spi2.0 thread. Additionally it was found that a "normal"
rpmsg_recv_done() took 11µs +/-2µs from its kref_get to kref_put. In
the error case the same sequence took about 215µs +/-10µs. Based on
this, an LLM was used to identify the size mismatch fixed here.

Allocate the buffers with DMA_CACHE_ALIGNED_LEN(dma_len) so they cover
the full mapped length, and use the same length for
dma_sync_single_for_cpu() to stay consistent with map and unmap.

With this patch applied, the same workload ran for more than 200 hours
without the problem reproducing.

Assisted-by: LLM
Fixes: faa8e404ad8e ("spi: imx: support dynamic burst length for ECSPI DMA mode")
Cc: stable@vger.kernel.org
Signed-off-by: Richard Leitner <richard.leitner@linux.dev>
---
 drivers/spi/spi-imx.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 79a6c1a60b0a0..3851c50dbe314 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -1578,11 +1578,13 @@ static int spi_imx_dma_tx_data_handle(struct spi_imx_data *spi_imx,
 		dma_data->dma_len = ALIGN(dma_data->data_len, BYTES_PER_32BITS_WORD);
 	}
 
-	dma_data->dma_tx_buf = kzalloc(dma_data->dma_len, GFP_KERNEL);
+	dma_data->dma_tx_buf = kzalloc(DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
+				       GFP_KERNEL);
 	if (!dma_data->dma_tx_buf)
 		return -ENOMEM;
 
-	dma_data->dma_rx_buf = kzalloc(dma_data->dma_len, GFP_KERNEL);
+	dma_data->dma_rx_buf = kzalloc(DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
+				       GFP_KERNEL);
 	if (!dma_data->dma_rx_buf) {
 		kfree(dma_data->dma_tx_buf);
 		return -ENOMEM;
@@ -1920,7 +1922,8 @@ static int spi_imx_dma_package_transfer(struct spi_imx_data *spi_imx,
 
 	/* Trim the DMA RX buffer and copy the actual data to rx_buf */
 	dma_sync_single_for_cpu(controller->dma_rx->device->dev, dma_data->dma_rx_addr,
-				dma_data->dma_len, DMA_FROM_DEVICE);
+				DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
+				DMA_FROM_DEVICE);
 	spi_imx_dma_rx_data_handle(spi_imx, dma_data, transfer->rx_buf + spi_imx->rx_offset,
 				   word_delay);
 	spi_imx->rx_offset += dma_data->data_len;

---
base-commit: 62f482ff73bf3ae88b0c899115527752cf9cbf13
change-id: 20261015-fix-spi-imx-dma-1bab95ea4863

Best regards,
--  
Richard Leitner <richard.leitner@linux.dev>

Re: [PATCH] spi: imx: fix slab corruption from undersized DMA bounce buffers

[Frank Li]

On Thu, Oct 15, 2026 at 10:58:00PM +0200, Richard Leitner wrote:
> [You don't often get email from richard.leitner@linux.dev. Learn why this is important at https://aka.ms/LearnAboutSenderIdentification ]
>
> Since commit faa8e404ad8e ("spi: imx: support dynamic burst length for
> ECSPI DMA mode"), the driver allocates its private DMA TX/RX buffers
> with kzalloc(dma_len), where dma_len is only rounded up to 4 bytes, but
> maps, syncs and unmaps them with DMA_CACHE_ALIGNED_LEN(dma_len), i.e.
> rounded up to the cache line size. As a result, the DMA API operates on
> memory beyond the end of the allocation.
>
> This was observed on a custom i.MX8MP platform with an mcp251xfd CAN
> controller under heavy RPMSG load, as a series of refcount_t warnings
> triggered from rpmsg_recv_done() in virtio_rpmsg_bus:
>
>   refcount_t: addition on 0; use-after-free.
>   refcount_t: underflow; use-after-free.
>   refcount_t: saturated; leaking memory.
>
> Leading finally to an "Unable to handle kernel paging request" oops.
> Reproducing this problem took between 30 minutes and roughly 30 hours
> under the same workload.
>
> Hardware watchpoints on the refcount of a struct rpmsg_endpoint showed
> it was overwritten from 2 to 1 by __pi_memcpy_generic() in the
> irq/155-spi2.0 thread. Additionally it was found that a "normal"
> rpmsg_recv_done() took 11µs +/-2µs from its kref_get to kref_put. In
> the error case the same sequence took about 215µs +/-10µs. Based on
> this, an LLM was used to identify the size mismatch fixed here.
>
> Allocate the buffers with DMA_CACHE_ALIGNED_LEN(dma_len) so they cover
> the full mapped length, and use the same length for
> dma_sync_single_for_cpu() to stay consistent with map and unmap.
>
> With this patch applied, the same workload ran for more than 200 hours
> without the problem reproducing.
>
> Assisted-by: LLM
> Fixes: faa8e404ad8e ("spi: imx: support dynamic burst length for ECSPI DMA mode")
> Cc: stable@vger.kernel.org
> Signed-off-by: Richard Leitner <richard.leitner@linux.dev>
> ---

Thanks you fix this.

Reviewed-by: Frank Li <Frank.Li@nxp.com>

>  drivers/spi/spi-imx.c | 9 ++++++---
>  1 file changed, 6 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
> index 79a6c1a60b0a0..3851c50dbe314 100644
> --- a/drivers/spi/spi-imx.c
> +++ b/drivers/spi/spi-imx.c
> @@ -1578,11 +1578,13 @@ static int spi_imx_dma_tx_data_handle(struct spi_imx_data *spi_imx,
>                 dma_data->dma_len = ALIGN(dma_data->data_len, BYTES_PER_32BITS_WORD);
>         }
>
> -       dma_data->dma_tx_buf = kzalloc(dma_data->dma_len, GFP_KERNEL);
> +       dma_data->dma_tx_buf = kzalloc(DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
> +                                      GFP_KERNEL);
>         if (!dma_data->dma_tx_buf)
>                 return -ENOMEM;
>
> -       dma_data->dma_rx_buf = kzalloc(dma_data->dma_len, GFP_KERNEL);
> +       dma_data->dma_rx_buf = kzalloc(DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
> +                                      GFP_KERNEL);
>         if (!dma_data->dma_rx_buf) {
>                 kfree(dma_data->dma_tx_buf);
>                 return -ENOMEM;
> @@ -1920,7 +1922,8 @@ static int spi_imx_dma_package_transfer(struct spi_imx_data *spi_imx,
>
>         /* Trim the DMA RX buffer and copy the actual data to rx_buf */
>         dma_sync_single_for_cpu(controller->dma_rx->device->dev, dma_data->dma_rx_addr,
> -                               dma_data->dma_len, DMA_FROM_DEVICE);
> +                               DMA_CACHE_ALIGNED_LEN(dma_data->dma_len),
> +                               DMA_FROM_DEVICE);
>         spi_imx_dma_rx_data_handle(spi_imx, dma_data, transfer->rx_buf + spi_imx->rx_offset,
>                                    word_delay);
>         spi_imx->rx_offset += dma_data->data_len;
>
> ---
> base-commit: 62f482ff73bf3ae88b0c899115527752cf9cbf13
> change-id: 20261015-fix-spi-imx-dma-1bab95ea4863
>
> Best regards,
> --
> Richard Leitner <richard.leitner@linux.dev>
>
>
>