Re: [PATCH v1] dt-bindings: qcom: geni-se: Rename qcom,geni-se.yaml to qcom,geni-se-qup.yaml

[Krzysztof Kozlowski <krzk@kernel.org>]

On 24/02/2025 14:25, Viken Dadhaniya wrote:
> 
> 
> On 2/24/2025 3:48 PM, Krzysztof Kozlowski wrote:
>> On 24/02/2025 09:47, Viken Dadhaniya wrote:
>>>
>>>
>>> On 2/21/2025 5:05 PM, Krzysztof Kozlowski wrote:
>>>> On 21/02/2025 09:54, Viken Dadhaniya wrote:
>>>>> The qcom,geni-se.yaml file describes the Qualcomm Universal Peripheral
>>>>> (QUP) wrapper and the common entities required by QUP to run any Serial
>>>>> Engine (SE) as I2C, SPI, UART, or I3C protocol.
>>>>>
>>>>> Rename qcom,geni-se.yaml to qcom,geni-se-qup.yaml to better reflect its
>>>>> association with QUP (Qualcomm Universal Peripheral) and the compatible
>>>>> string.
>>>>>
>>>>> Signed-off-by: Viken Dadhaniya <quic_vdadhani@quicinc.com>
>>>>> ---
>>>>>    .../soc/qcom/{qcom,geni-se.yaml => qcom,geni-se-qup.yaml}       | 2 +-
>>>>>    1 file changed, 1 insertion(+), 1 deletion(-)
>>>>>    rename Documentation/devicetree/bindings/soc/qcom/{qcom,geni-se.yaml => qcom,geni-se-qup.yaml} (98%)
>>>>>
>>>>
>>>> That's just churn for no real gain. Not even tested churn.
>>>
>>> That's just churn for no real gain.
>>>
>>> We made this change based on below plan, we think this will be helpful.
>>>
>>> 1. Rename qcom,geni-se.yaml to qcom,geni-se-qup.yaml. Reason at 2 below.
>>
>> There is no reason 2 at this point. You split your patchsets
>> incorrectly. At this point this is churn, without gain. No users of this
>> rename, no benefits.
>>
>>> 2. Create qcom,geni-se.yaml with shared properties for SE-protocol (spi,
>>> i2c, uart) nodes. This will be helpful for the shared schema in the
>>> ongoing changes
>>
>> Then post it, instead of sending something which makes no sense on its own.
> 
> Should I include this change in v3 of the following serial patch?
> 
> https://lore.kernel.org/linux-arm-msm/f090d637-1ef1-4967-b5bc-6bfce3d7130e@kernel.org/T/
> 
> I hope the approach below is fine for you:
> 
> 1. Rename qcom,geni-se.yaml to qcom,geni-se-qup.yaml.

I still do not see any need nor justification for above.

> 2. Create qcom,geni-se.yaml with shared properties for SE-protocol (i2c, 
> spi, uart) nodes.

Look how other common qcom schemas are named :/


Best regards,
Krzysztof