Re: [PATCH v3 3/3] arm64: qcom: sc7280: Move phy, perst to root port node

[Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>]

On 6/1/2025 12:35 PM, Manivannan Sadhasivam wrote:
> On Sat, Apr 19, 2025 at 10:49:26AM +0530, Krishna Chaitanya Chundru wrote:
>> There are many places we agreed to move the wake and perst gpio's
>> and phy etc to the pcie root port node instead of bridge node[1].
> 
> Same comment as binding patch applies here.
> 
>>
>> So move the phy, phy-names, wake-gpio's in the root port.
> 
> You are not moving any 'wake-gpios' property.
> 
ack I will remove it.
>> There is already reset-gpio defined for PERST# in pci-bus-common.yaml,
>> start using that property instead of perst-gpio.
>>
>> [1] https://lore.kernel.org/linux-pci/20241211192014.GA3302752@bhelgaas/
>>
>> Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
>> ---
>>   arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts   | 5 ++++-
>>   arch/arm64/boot/dts/qcom/sc7280-herobrine.dtsi | 5 ++++-
>>   arch/arm64/boot/dts/qcom/sc7280-idp.dtsi       | 5 ++++-
>>   arch/arm64/boot/dts/qcom/sc7280.dtsi           | 6 ++----
>>   4 files changed, 14 insertions(+), 7 deletions(-)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
>> index 7a36c90ad4ec8b52f30b22b1621404857d6ef336..3dd58986ad5da0f898537a51715bb5d0fecbe100 100644
>> --- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
>> +++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
>> @@ -709,8 +709,11 @@ &mdss_edp_phy {
>>   	status = "okay";
>>   };
>>   
>> +&pcie1_port0 {
>> +	reset-gpios = <&tlmm 2 GPIO_ACTIVE_LOW>;
>> +};
>> +
>>   &pcie1 {
>> -	perst-gpios = <&tlmm 2 GPIO_ACTIVE_LOW>;
>>   
>>   	pinctrl-0 = <&pcie1_reset_n>, <&pcie1_wake_n>;
>>   	pinctrl-names = "default";
> 
> What about the pinctrl properties? They should also be moved.
> 
pinctrl can still reside in the host bridge node, which has
all the gpio's for all the root ports. If we move them to the
root ports we need to explicitly apply pinctrl settings as these
not tied with the driver yet.

- Krishna Chaitanya.
> - Mani
>