[PATCH v5 1/3] arm64: dts: qcom: x1e80100-vivobook-s15: Use the samsung,atna33xc20 panel driver

[Maud Spierings via B4 Relay <devnull+maud_spierings.hotmail.com@kernel.org>]

From: Maud Spierings <maud_spierings@hotmail.com>

The Asus vivobook s15 uses the ATNA56AC03 panel.
This panel is controlled by the atna33xc20 driver instead of the generic
edp-panel driver

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Signed-off-by: Maud Spierings <maud_spierings@hotmail.com>
---
 .../arm64/boot/dts/qcom/x1e80100-asus-vivobook-s15.dts | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/x1e80100-asus-vivobook-s15.dts b/arch/arm64/boot/dts/qcom/x1e80100-asus-vivobook-s15.dts
index f25991b887de3fca0092c5f81c881c5d8bd71aac..8cdb2888d10a1dfc0c28480b6636584ab06853bb 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100-asus-vivobook-s15.dts
+++ b/arch/arm64/boot/dts/qcom/x1e80100-asus-vivobook-s15.dts
@@ -407,9 +407,13 @@ &mdss_dp3 {
 
 	aux-bus {
 		panel {
-			compatible = "edp-panel";
+			compatible = "samsung,atna56ac03", "samsung,atna33xc20";
+			enable-gpios = <&pmc8380_3_gpios 4 GPIO_ACTIVE_HIGH>;
 			power-supply = <&vreg_edp_3p3>;
 
+			pinctrl-0 = <&edp_bl_en>;
+			pinctrl-names = "default";
+
 			port {
 				edp_panel_in: endpoint {
 					remote-endpoint = <&mdss_dp3_out>;
@@ -475,6 +479,18 @@ &pcie6a_phy {
 	status = "okay";
 };
 
+&pmc8380_3_gpios {
+	edp_bl_en: edp-bl-en-state {
+		pins = "gpio4";
+		function = "normal";
+		power-source = <1>;
+		qcom,drive-strength = <2>;
+		bias-pull-down;
+		input-disable;
+		output-enable;
+	};
+};
+
 &qupv3_0 {
 	status = "okay";
 };

-- 
2.47.1