* [PATCH 6.12 224/565] drm/bridge: display-connector: dont set OP_DETECT for DisplayPorts
[not found] <20251111004526.816196597@linuxfoundation.org>
@ 2025-11-11 0:41 ` Greg Kroah-Hartman
0 siblings, 0 replies; only message in thread
From: Greg Kroah-Hartman @ 2025-11-11 0:41 UTC (permalink / raw)
To: stable
Cc: Greg Kroah-Hartman, patches, Bjorn Andersson, Konrad Dybcio,
linux-arm-msm, Laurent Pinchart, Dmitry Baryshkov, Sasha Levin
6.12-stable review patch. If anyone has any objections, please let me know.
------------------
From: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
[ Upstream commit cb640b2ca54617f4a9d4d6efd5ff2afd6be11f19 ]
Detecting the monitor for DisplayPort targets is more complicated than
just reading the HPD pin level: it requires reading the DPCD in order to
check what kind of device is attached to the port and whether there is
an actual display attached.
In order to let DRM framework handle such configurations, disable
DRM_BRIDGE_OP_DETECT for dp-connector devices, letting the actual DP
driver perform detection. This still keeps DRM_BRIDGE_OP_HPD enabled, so
it is valid for the bridge to report HPD events.
Currently inside the kernel there are only two targets which list
hpd-gpios for dp-connector devices: arm64/qcom/qcs6490-rb3gen2 and
arm64/qcom/sa8295p-adp. Both should be fine with this change.
Cc: Bjorn Andersson <andersson@kernel.org>
Cc: Konrad Dybcio <konradybcio@kernel.org>
Cc: linux-arm-msm@vger.kernel.org
Acked-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Link: https://lore.kernel.org/r/20250802-dp-conn-no-detect-v1-1-2748c2b946da@oss.qualcomm.com
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
drivers/gpu/drm/bridge/display-connector.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/bridge/display-connector.c b/drivers/gpu/drm/bridge/display-connector.c
index ab8e00baf3f16..e5817f5439144 100644
--- a/drivers/gpu/drm/bridge/display-connector.c
+++ b/drivers/gpu/drm/bridge/display-connector.c
@@ -363,7 +363,8 @@ static int display_connector_probe(struct platform_device *pdev)
if (conn->bridge.ddc)
conn->bridge.ops |= DRM_BRIDGE_OP_EDID
| DRM_BRIDGE_OP_DETECT;
- if (conn->hpd_gpio)
+ /* Detecting the monitor requires reading DPCD */
+ if (conn->hpd_gpio && type != DRM_MODE_CONNECTOR_DisplayPort)
conn->bridge.ops |= DRM_BRIDGE_OP_DETECT;
if (conn->hpd_irq >= 0)
conn->bridge.ops |= DRM_BRIDGE_OP_HPD;
--
2.51.0
^ permalink raw reply related [flat|nested] only message in thread