Re: [PATCH net-next v2 12/14] net: ethernet: qualcomm: Initialize PPE L2 bridge settings

[Lei Wei <quic_leiwei@quicinc.com>]

On 1/13/2025 9:37 PM, Andrew Lunn wrote:
>>> Why is learning needed on physical ports? In general, switches forward
>>> unknown destination addresses to the CPU. Which is what you want when
>>> the ports are isolated from each other. Everything goes to the
>>> CPU. But maybe this switch does not work like this?
>>>
>>
>> L2 forwarding can be disabled in PPE in two ways:
>>
>> 1.) Keep the learning enabled (which is the default HW setting) and
>> configure the FDB-miss-action to redirect to CPU.
>>
>> This works because even if FDB learning is enabled, we need to represent
>> the bridge and the physical ports using their 'virtual switch instance'
>> (VSI) in the PPE HW, and create the 'port membership' for the bridge VSI
>> (the list of slave ports), before FDB based forwarding can take place. Since
>> we do not yet support switchdev, these VSI are not created and packets are
>> always forwarded to CPU due to FDB miss.
>>
>> (or)
>>
>> 2.) Explicitly disable learning either globally or on the ports.
>>
>> With method 1 we can achieve packet forwarding to CPU without explicitly
>> disabling learning. When switchdev is enabled later, L2 forwarding can be
>> enabled as a natural extension on top of this configuration. So we have
>> chosen the first approach.
> 
> How does ageing work in this setup? Will a cable unplug/plug flush all
> the learned entries? Is ageing set to some reasonable default in case
> a MAC address moves?
> 

I would like to clarify that representing the bridge and its slave ports
inside PPE (using a VSI - virtual switch instance) is a pre-requisite 
before learning can take place on a port. At this point, since switchdev
is not enabled, VSI is not created for port/bridge and hence FDB 
learning does not take place. Later when we enable switchdev and 
represent the bridge/slave-ports in PPE, FDB learning will automatically 
occur on top of this initial configuration. I will add this note in the 
comments and commit message to make it clear.

Regarding FDB entry ageing (when switchdev is enabled later), MAC 
address move can be automatically detected and old entry flushed by the 
PPE. However for link change events on a port, PPE will rely on software 
to flush FDB entries for the port.

> 	Andrew