Re: [PATCH V2 3/5] clk: qcom: gcc-qdu1000: Update GCC clocks as per the latest hw version

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 6.07.2023 12:51, Imran Shaik wrote:
> 
> 
> On 6/28/2023 4:36 PM, Konrad Dybcio wrote:
>> On 28.06.2023 11:28, Imran Shaik wrote:
>>> Add support for gcc_ddrss_ecpri_gsi_clk and update the GCC clkref clocks
>>> as per the latest hardware version of QDU1000 and QRU100 SoCs.
>>>
>>> Co-developed-by: Taniya Das <quic_tdas@quicinc.com>
>>> Signed-off-by: Taniya Das <quic_tdas@quicinc.com>
>>> Signed-off-by: Imran Shaik <quic_imrashai@quicinc.com>
>>> ---
[...]

>>>           .enable_reg = 0x9c004,
>>>           .enable_mask = BIT(0),
>>>           .hw.init = &(const struct clk_init_data) {
>>>               .name = "gcc_pcie_0_clkref_en",
>>> -            .ops = &clk_branch_ops,
>>> +            .ops = &clk_branch2_ops,
>> This sounds like a separate fix, clk_branch_ops seems to only concern
>> 10+yo chips.
>>
>> Konrad
> 
> Sure, will split this patch and push the next series.
One more nit, I noticed that a lot of QUIC folks respond to the comments
to their revision-N and send revision-(N+1) like 5 seconds later..

This maybe does not concern this message, as all you did is said "ok willfix",
but if you have some sort of a company-wide "upstream best practices" board,
you may add something like "wait a bit to let others respond to your email"

Konrad

> 
> Thanks,
> Imran
> 
>>>           },
>>>       },
>>>   };
>>> @@ -2274,14 +2293,13 @@ static struct clk_branch gcc_tsc_etu_clk = {
>>>     static struct clk_branch gcc_usb2_clkref_en = {
>>>       .halt_reg = 0x9c008,
>>> -    .halt_bit = 31,
>>> -    .halt_check = BRANCH_HALT_ENABLE,
>>> +    .halt_check = BRANCH_HALT,
>>>       .clkr = {
>>>           .enable_reg = 0x9c008,
>>>           .enable_mask = BIT(0),
>>>           .hw.init = &(const struct clk_init_data) {
>>>               .name = "gcc_usb2_clkref_en",
>>> -            .ops = &clk_branch_ops,
>>> +            .ops = &clk_branch2_ops,
>>>           },
>>>       },
>>>   };
>>> @@ -2523,6 +2541,8 @@ static struct clk_regmap *gcc_qdu1000_clocks[] = {
>>>       [GCC_AGGRE_NOC_ECPRI_GSI_CLK] = &gcc_aggre_noc_ecpri_gsi_clk.clkr,
>>>       [GCC_PCIE_0_PHY_AUX_CLK_SRC] = &gcc_pcie_0_phy_aux_clk_src.clkr,
>>>       [GCC_PCIE_0_PIPE_CLK_SRC] = &gcc_pcie_0_pipe_clk_src.clkr,
>>> +    [GCC_GPLL1_OUT_EVEN] = &gcc_gpll1_out_even.clkr,
>>> +    [GCC_DDRSS_ECPRI_GSI_CLK] = &gcc_ddrss_ecpri_gsi_clk.clkr,
>>>   };
>>>     static const struct qcom_reset_map gcc_qdu1000_resets[] = {