Re: [PATCH 2/2] clk: qcom: reset: Use the correct type of sleep/delay based on length

[Stephan Gerhold <stephan@gerhold.net>]

On Wed, Jul 26, 2023 at 03:26:20PM +0200, Konrad Dybcio wrote:
> Based on the length of the delay (see: [1]), use the correct sleep/delay
> functions.
> 
> [1] https://www.kernel.org/doc/Documentation/timers/timers-howto.txt
> Fixes: b36ba30c8ac6 ("clk: qcom: Add reset controller support")

If anything this would fix 2cb8a39b6781 ("clk: qcom: reset: Allow
specifying custom reset delay") since before there was udelay(1)
hardcoded (which is correct).

But given that we just allowed small delays <= 255us so far it was
probably okay-ish, so I think it's not worth bringing this to the
attention of backporters with the Fixes tag.

> Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
> ---
>  drivers/clk/qcom/reset.c | 8 +++++++-
>  1 file changed, 7 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/clk/qcom/reset.c b/drivers/clk/qcom/reset.c
> index 0e914ec7aeae..928995c3f369 100644
> --- a/drivers/clk/qcom/reset.c
> +++ b/drivers/clk/qcom/reset.c
> @@ -14,9 +14,15 @@
>  static int qcom_reset(struct reset_controller_dev *rcdev, unsigned long id)
>  {
>  	struct qcom_reset_controller *rst = to_qcom_reset_controller(rcdev);
> +	u16 delay_us = rst->reset_map[id].udelay ?: 1;
>  
>  	rcdev->ops->assert(rcdev, id);
> -	udelay(rst->reset_map[id].udelay ?: 1); /* use 1 us as default */
> +
> +	if (delay_us < 10)
> +		udelay(delay_us);
> +	else
> +		usleep_range(delay_us, delay_us + 5);
> +

There is fsleep() that implements this logic in a similar way already:

	fsleep(rst->reset_map[id].udelay ?: 1); /* use 1 us as default */

Thanks,
Stephan