Re: [PATCH v6 1/6] tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state

[Rajendra Nayak <rnayak@codeaurora.org>]

On 6/25/2020 10:38 AM, Bjorn Andersson wrote:
> On Mon 15 Jun 05:02 PDT 2020, Rajendra Nayak wrote:
> 
>> geni serial needs to express a perforamnce state requirement on CX
>> powerdomain depending on the frequency of the clock rates.
>> Use OPP table from DT to register with OPP framework and use
>> dev_pm_opp_set_rate() to set the clk/perf state.
>>
>> Signed-off-by: Rajendra Nayak <rnayak@codeaurora.org>
>> Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
>> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
>> Cc: Akash Asthana <akashast@codeaurora.org>
>> Cc: linux-serial@vger.kernel.org
> 
> Picked up patch 1 and 2 through the qcom tree.

thanks Bjorn

> As Mark requested, please don't lump together patches that doesn't
> actually depend on each other in the same series - it's quite confusing
> to know what to pick and not.

Sorry for the confusion, I will try and split them into driver specific patches henceforth.
For this series though, I see that you have merged the entire ICC series for
QUP and QSPI into for-next of the qcom tree.
In which case it perhaps makes sense for you to pull in the QSPI change from this series
as well? i.e PATCH 6/6.
If so, I will rebase the patch on your for-next and resend (Its already Ack'ed by Mark)

thanks,
Rajendra

-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation