[Bluez-users] Re: Jerky MX900 mouse movement with 2.6.7-mh1, hidp and hidd

[Vesa Halttunen <vesuri@jormas.com>]

Hi,

On Mon, 2004-06-21 at 00:05, Marcel Holtmann wrote:
> actually if you use the default hcid.conf from bluez-utils-2.7 and
> startup hcid this should be all done at device init. If not, then you
> must use "hciconfig hci0 lp ..." for it.

ah, yes. Role switching and sniff mode were already enabled in my
hcid.conf.

> hci0:   Type: USB
>         BD Address: 00:02:xx:xx:xx:xx ACL MTU: 384:8  SCO MTU: 64:8
>         Link policy: RSWITCH HOLD SNIFF PARK 

That's what my Link policy says as well with "hciconfig hci0 lp".

> > hcitool con shows the keyboard and the mouse as follows:
> > Connections:
> >         > ACL ..:..:..:..:..:.. handle 44 state 1 lm MASTER
> >         > ACL ..:..:..:..:..:.. handle 41 state 1 lm MASTER
> This is the outgoing case and that is never a problem. But the devices
> reconnect and then you will see two slaves and this means scatternet.

OK. I disconnected the devices and saw them reconnect and for a second
they were marked as SLAVEs but then became MASTERs. I guess that's how
it should be?

So... everything seems to be fine, but still, mouse movement is jerky.
I tried switching hyperthreading off because I couldn't think of
anything else but this didn't help.

Any suggestions? :)

Thanks,

-Vesa
-- 
            · Vesa Halttunen - http://www.jormas.com/~vesuri/ ·



-------------------------------------------------------
This SF.Net email is sponsored by The 2004 JavaOne(SM) Conference
Learn from the experts at JavaOne(SM), Sun's Worldwide Java Developer
Conference, June 28 - July 1 at the Moscone Center in San Francisco, CA
REGISTER AND SAVE! http://java.sun.com/javaone/sf Priority Code NWMGYKND
_______________________________________________
Bluez-users mailing list
Bluez-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-users