[PATCH v2 02/12] Bluetooth: btusb: Fix BD_ADDR byte order in btusb_set_bdaddr_wcn6855()

[Zijun Hu <zijun.hu@oss.qualcomm.com>]

btusb_set_bdaddr_wcn6855() sends the address without swapping byte
order for VSC 0xFC14, but the command expects the address in reversed
byte order compared to other HCI commands like HCI_Create_Connection,
resulting in a wrong BD_ADDR being set.

btmon log on WCN6855 shows VSC 0xFC14 is sent with swapped bytes
11 22 33 44 55 66, and Read BD ADDR returns the expected address
11:22:33:44:55:66:

  < HCI Command: Vendor (0x3f|0x0014) plen 6                  #3 [hci0]
          11 22 33 44 55 66
  > HCI Event: Command Complete (0x0e) plen 4                  #4 [hci0]
        Vendor (0x3f|0x0014) ncmd 1
          Status: Success (0x00)
  < HCI Command: Read BD ADDR (0x04|0x0009) plen 0            #11 [hci0]
  > HCI Event: Command Complete (0x0e) plen 10                #12 [hci0]
        Read BD ADDR (0x04|0x0009) ncmd 1
          Status: Success (0x00)
          Address: 11:22:33:44:55:66 (OUI 11-22-33)

Fix by swapping the input address before issuing the command.

Fixes: b40f58b97386 ("Bluetooth: btusb: Add Qualcomm Bluetooth SoC WCN6855 support")
Signed-off-by: Zijun Hu <zijun.hu@oss.qualcomm.com>
---
 drivers/bluetooth/btusb.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 7f14ce96319b..17573749adda 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -3072,14 +3072,15 @@ static int btusb_set_bdaddr_ath3012(struct hci_dev *hdev,
 static int btusb_set_bdaddr_wcn6855(struct hci_dev *hdev,
 				const bdaddr_t *bdaddr)
 {
+	bdaddr_t bdaddr_swapped;
 	struct sk_buff *skb;
-	u8 buf[6];
 	long ret;
 
-	memcpy(buf, bdaddr, sizeof(bdaddr_t));
+	baswap(&bdaddr_swapped, bdaddr);
 
-	skb = __hci_cmd_sync_ev(hdev, 0xfc14, sizeof(buf), buf,
-				HCI_EV_CMD_COMPLETE, HCI_INIT_TIMEOUT);
+	skb = __hci_cmd_sync_ev(hdev, 0xfc14, sizeof(bdaddr_swapped),
+				&bdaddr_swapped, HCI_EV_CMD_COMPLETE,
+				HCI_INIT_TIMEOUT);
 	if (IS_ERR(skb)) {
 		ret = PTR_ERR(skb);
 		bt_dev_err(hdev, "Change address command failed (%ld)", ret);

-- 
2.34.1