Re: [PATCH 05/11] dt-bindings: clock: qcom: gcc-ipq9574: Add Q6 gcc clock control

[Manikanta Mylavarapu <quic_mmanikan@quicinc.com>]

On 5/8/2023 7:59 PM, Manikanta Mylavarapu wrote:
> 
> 
> On 3/7/2023 8:49 PM, Krzysztof Kozlowski wrote:
>> On 07/03/2023 05:41, Manikanta Mylavarapu wrote:
>>> Add support for the QDSP6 gcc clock control used on IPQ9574
>>> based devices. This would allow mpd remoteproc driver to control
>>> the required gcc clocks to bring the subsystem out of reset.
>>>
>>> Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@quicinc.com>
>>> ---
>>>   include/dt-bindings/clock/qcom,ipq9574-gcc.h | 159 ++++++++++---------
>>>   1 file changed, 83 insertions(+), 76 deletions(-)
>>>
>>> diff --git a/include/dt-bindings/clock/qcom,ipq9574-gcc.h 
>>> b/include/dt-bindings/clock/qcom,ipq9574-gcc.h
>>> index c89e96d568c6..8bd6350ecd56 100644
>>> --- a/include/dt-bindings/clock/qcom,ipq9574-gcc.h
>>> +++ b/include/dt-bindings/clock/qcom,ipq9574-gcc.h
>>> @@ -138,80 +138,87 @@
>>>   #define WCSS_AHB_CLK_SRC                129
>>>   #define GCC_Q6_AHB_CLK                    130
>>>   #define GCC_Q6_AHB_S_CLK                131
>>> -#define GCC_WCSS_ECAHB_CLK                132
>>> -#define GCC_WCSS_ACMT_CLK                133
>>
>> That's an ABI break, if file was accepted. Or a very weird change
>> anyway, if it wasn't (why adding entry and immediately changing it?).
>>
>> Best regards,
>> Krzysztof
>>
> 
> I will add new macros at the end instead in middle.
> 
> Thanks & Regards,
> Manikanta.

Clocks in multipd architecture will be handled by QDSP6 firmware.
So i am going to remove clock macros and drop this patch.

Thanks & Regards,
Manikanta.