Re: [PATCH 1/3] arm64: dts: fvp: Add CPU idle states for Rev C model

["Rob Herring (Arm)" <robh@kernel.org>]

On Thu, 08 May 2025 11:32:23 +0100, Sudeep Holla wrote:
> Add CPU idle state definitions to the FVP Rev C device tree to enable
> support for CPU lower power modes. This allows the system to properly
> enter low power states during idle. It is disabled by default as it is
> know to impact performance on the models.
> 
> Note that the power_state parameter(arm,psci-suspend-param) doesn't use
> the Extended StateID format for compatibility reasons on FVP.
> 
> Tested on the FVP Rev C model with PSCI support enabled firmware.
> 
> Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
> ---
>  arch/arm64/boot/dts/arm/fvp-base-revc.dts | 32 +++++++++++++++++++++++
>  1 file changed, 32 insertions(+)
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


This patch series was applied (using b4) to base:
 Base: attempting to guess base-commit...
 Base: tags/v6.15-rc1-1-g59529bbe642d (exact match)

If this is not the correct base, please add 'base-commit' tag
(or use b4 which does this automatically)

New warnings running 'make CHECK_DTBS=y for arch/arm64/boot/dts/arm/' for 20250508103225.354925-1-sudeep.holla@arm.com:

arch/arm64/boot/dts/arm/fvp-base-revc.dtb: idle-states: entry-method:0: 'psci' was expected
	from schema $id: http://devicetree.org/schemas/cpu/idle-states.yaml#
arch/arm64/boot/dts/arm/fvp-base-revc.dtb: timer@2a810000 (arm,armv7-timer-mem): #size-cells: 1 was expected
	from schema $id: http://devicetree.org/schemas/timer/arm,arch_timer_mmio.yaml#