Re: [PATCH 1/2] dt-bindings: regulator: add SGMicro SGM3804

["Rob Herring (Arm)" <robh@kernel.org>]

On Sun, 10 May 2026 23:45:26 +0700, Alexandre Hamamdjian wrote:
> The SGMicro SGM3804 is an I2C-controlled positive and negative output
> charge-pump regulator. It is commonly used to provide the AVDD and AVEE
> supplies for display panels, and exposes two reset GPIOs to sequence the
> positive and negative output rails independently.
> 
> Document the binding for the new compatible "sgmicro,sgm3804" so it can
> be referenced by board device trees and the matching driver, and add a
> MAINTAINERS entry covering both the binding and the upcoming driver.
> 
> Co-developed-by: Philippe Simons <simons.philippe@gmail.com>
> Signed-off-by: Philippe Simons <simons.philippe@gmail.com>
> Signed-off-by: Alexandre Hamamdjian <azkali.limited@gmail.com>
> ---
>  .../bindings/regulator/sgmicro,sgm3804.yaml        | 60 ++++++++++++++++++++++
>  MAINTAINERS                                        |  7 +++
>  2 files changed, 67 insertions(+)
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/regulator/sgmicro,sgm3804.example.dtb: regulator@3e (sgmicro,sgm3804): reset-gpios: [[4294967295, 10, 0], [4294967295, 11, 0]] is too long
	from schema $id: http://devicetree.org/schemas/gpio/gpio-consumer-common.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.kernel.org/project/devicetree/patch/20260510-sgm3804-v1-1-e5e8799e0aa0@gmail.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.