[PATCH v3 1/2] arm64: allwinner: a64: Add RTC clock to phandle 32kHz external oscillator

[PATCH v3 1/2] arm64: allwinner: a64: Add RTC clock to phandle 32kHz external oscillator

[Jagan Teki]

Outside of SOC few chips need external clock source
through RTC example Wifi chip. So RTC clock nodes to
phandle 32kHz external oscillator.

prefix rtc- with clock-output-names defined in
dt-binding to avoid confusion with existing osc32k name.

Signed-off-by: Jagan Teki <jagan-dyjBcgdgk7Pe9wHmmfpqLFaTQe2KTcn/@public.gmane.org>
---
Changes for v3:
- squash of previous v2 patch

 arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
index 1b2ef28c42bd..82516aec4153 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
@@ -634,6 +634,9 @@
 			reg = <0x01f00000 0x54>;
 			interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>,
 				     <GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>;
+			clock-output-names = "rtc-osc32k", "rtc-osc32k-out";
+			clocks = <&osc32k>;
+			#clock-cells = <1>;
 		};
 
 		r_intc: interrupt-controller@1f00c00 {
-- 
2.14.3

[PATCH v3 2/2] arm64: allwinner: a64-amarula-relic: Enable AP6330 WiFi support

[Jagan Teki]

Enable AP6330 WiFi/BT combo chip on Amarula A64-Relic board:
- WiFi SDIO interface is connected to MMC1
- WiFi WL-PMU-EN pin connected to gpio PL2: attach to mmc-pwrseq
- WiFi WL-WAKE-AP pin connected to gpio PL3
- 32kHz external oscillator gate clock from RTC

Signed-off-by: Jagan Teki <jagan-dyjBcgdgk7Pe9wHmmfpqLFaTQe2KTcn/@public.gmane.org>
---
Changes for v3:
- move dtsi change in separate patch
Changes for v2:
- Move external rtc clock nodes into main rtc node definition
  of sun50i-a64.dtsi

 .../dts/allwinner/sun50i-a64-amarula-relic.dts     | 31 ++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
index ce4a256ff086..eac4793c8502 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
@@ -21,12 +21,43 @@
 	chosen {
 		stdout-path = "serial0:115200n8";
 	};
+
+	wifi_pwrseq: wifi-pwrseq {
+		compatible = "mmc-pwrseq-simple";
+		clocks = <&rtc 1>;
+		clock-names = "ext_clock";
+		reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* WL-PMU-EN: PL2 */
+	};
 };
 
 &ehci0 {
 	status = "okay";
 };
 
+&mmc1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc1_pins>;
+	vmmc-supply = <&reg_dcdc1>;
+	/*
+	 * Schematic shows both dldo4 and eldo1 connected for vcc-io-wifi, but
+	 * dldo4 connection shows DNP(Do Not Populate) and eldo1 connected with
+	 * 0Ohm register to vcc-io-wifi so eldo1 is used.
+	 */
+	vqmmc-supply = <&reg_eldo1>;
+	mmc-pwrseq = <&wifi_pwrseq>;
+	bus-width = <4>;
+	non-removable;
+	status = "okay";
+
+	brcmf: wifi@1 {
+		reg = <1>;
+		compatible = "brcm,bcm4329-fmac";
+		interrupt-parent = <&r_pio>;
+		interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>;	/* WL-WAKE-AP: PL3 */
+		interrupt-names = "host-wake";
+	};
+};
+
 &mmc2 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc2_pins>;
-- 
2.14.3

Re: [PATCH v3 2/2] arm64: allwinner: a64-amarula-relic: Enable AP6330 WiFi support

[Maxime Ripard]

[-- Attachment #1: Type: text/plain, Size: 561 bytes --]

On Fri, Jun 01, 2018 at 11:05:27PM +0530, Jagan Teki wrote:
> Enable AP6330 WiFi/BT combo chip on Amarula A64-Relic board:
> - WiFi SDIO interface is connected to MMC1
> - WiFi WL-PMU-EN pin connected to gpio PL2: attach to mmc-pwrseq
> - WiFi WL-WAKE-AP pin connected to gpio PL3
> - 32kHz external oscillator gate clock from RTC
> 
> Signed-off-by: Jagan Teki <jagan-dyjBcgdgk7Pe9wHmmfpqLFaTQe2KTcn/@public.gmane.org>

Applied both, thanks

Maxime

-- 
Maxime Ripard, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com