Re: [PATCH 1/3] dt-bindings: interrupt-controller: Actions external interrupt controller

[Rob Herring <robh@kernel.org>]

On Tue, Jul 24, 2018 at 05:02:17PM +0200, Parthiban Nallathambi wrote:
> Actions Semi OWL family SoC's provides support for external interrupt
> controller to be connected and controlled using SIRQ pins. S500, S700
> and S900 provides 3 SIRQ lines and works independently for 3 external
> interrupt controllers.
> 
> Signed-off-by: Parthiban Nallathambi <pn@denx.de>
> Signed-off-by: Saravanan Sekar <sravanhome@gmail.com>
> ---
>  .../interrupt-controller/actions,owl-sirq.txt      | 34 ++++++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/interrupt-controller/actions,owl-sirq.txt
> 
> diff --git a/Documentation/devicetree/bindings/interrupt-controller/actions,owl-sirq.txt b/Documentation/devicetree/bindings/interrupt-controller/actions,owl-sirq.txt
> new file mode 100644
> index 000000000000..c5f8a29573c8
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/interrupt-controller/actions,owl-sirq.txt
> @@ -0,0 +1,34 @@
> +Actions Semi Owl SoCs SIRQ interrupt controller
> +
> +S500, S700 and S900 SoC's from Actions provides interface, in which external
> +interrupt controller can be connected. It has the following properties:
> +
> +- inputs three interrupt signal from external interrupt controller
> +
> +Required properties:
> +
> +- compatible: should be one of the following
> +	"actions,s700-sirq"
> +	"actions,s900-sirq"
> +- reg: physical base address of the controller and length of memory mapped.
> +- interrupt-controller: identifies the node as an interrupt controller
> +- #interrupt-cells: specifies the number of cells needed to encode an interrupt
> +  source, should be 2.
> +- interrupts: specifies the interrupt line in the interrupt controller and
> +  interrupt type (level or edge triggered)

Need to state there are 3 interrupts.

> +- sampling-rate-24m: this means the external controller's interrupts can be

Needs a vendor prefix.

> +  sampled at 24MHz. Sampling can be specified for each SIRQ lines, as an array
> +  element. By default, all lines are sampled at 32KHz.
> +
> +Example:
> +
> +sirq: interrupt-controller@e01b0000 {
> +	compatible = "actions,s700-sirq";
> +	reg = <0 0xe01b0000 0 0x1000>;
> +	interrupts = <GIC_SPI 13 IRQ_TYPE_LEVEL_HIGH>,
> +		<GIC_SPI 14 IRQ_TYPE_LEVEL_HIGH>,
> +		<GIC_SPI 15 IRQ_TYPE_LEVEL_HIGH>;
> +	interrupt-controller;
> +	#interrupt-cells = <2>;
> +	sampling-rate-24m = <0 0 1>;
> +};
> -- 
> 2.14.4
>