[PATCH v2 0/3] arm64: boot: dts: ti: k3-am62l: allow WKUP UART wakeup from LPM

[Kendall Willis <k-willis@ti.com>]

K3 TI AM62L SoC supports wakeup from WKUP UART when the SoC is in the
DeepSleep low power mode. To allow wakeup from WKUP UART the target-module
device tree node is enabled. The ti-sysc interconnect target module driver
is used to configure the the SYSCONFIG related registers. In this case,
the interconnect target module node configures the WKUP UART to be able to
wakeup from system suspend. The SYSC register is used to enable wakeup
from system suspend for the WKUP UART. Refer to 14.7.2.5 UART in the
AM62L Techincal Reference Manual for registers referenced [1].

Previous TI SoCs configure the WKUP UART to wakeup from system suspend
using the ti-sysc interconnect target module driver. Refer to commit
ce27f7f9e328 ("arm64: dts: ti: k3-am62-wakeup: Configure ti-sysc for
wkup_uart0") for an example of this.

Testing
-------
Tested on AM62L EVM.

[1] https://www.ti.com/lit/ug/sprujb4a/sprujb4a.pdf

Signed-off-by: Kendall Willis <k-willis@ti.com>
---
Changes in v2:
- Change subject of commit "arm64: boot: dts: ti: k3-am62l3-evm: enable
  target-module node" to better match the code logic of the patch.
- Link to v1: https://lore.kernel.org/r/20251230-wkup-uart-wakeup-v1-0-cd6e15f8d956@ti.com

---
Kendall Willis (3):
      arm64: dts: ti: k3-am62l: include WKUP_UART0 in wakeup peripheral window
      arm64: boot: dts: ti: k3-am62l-wakeup: create label for target-module
      arm64: boot: dts: ti: k3-am62l3-evm: enable target-module node

 arch/arm64/boot/dts/ti/k3-am62l-wakeup.dtsi | 2 +-
 arch/arm64/boot/dts/ti/k3-am62l.dtsi        | 4 ++--
 arch/arm64/boot/dts/ti/k3-am62l3-evm.dts    | 4 ++++
 3 files changed, 7 insertions(+), 3 deletions(-)
---
base-commit: 6cd6c12031130a349a098dbeb19d8c3070d2dfbe
change-id: 20251230-wkup-uart-wakeup-8bbc95aa8f8e

Best regards,
-- 
Kendall Willis <k-willis@ti.com>