[PATCH v7 01/11] dt-bindings: iio: adc: hx711: clean up existing binding text

[Piyush Patle <piyushpatle228@gmail.com>]

Rewrite the binding description and property text so it describes the
existing HX711 hardware behavior directly instead of documenting old
driver implementation details.

Also clarify that clock-frequency controls the SCK bit-bang timing.

No functional change.

Signed-off-by: Piyush Patle <piyushpatle228@gmail.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@intel.com>
---
 .../bindings/iio/adc/avia-hx711.yaml          | 25 ++++++++-----------
 1 file changed, 10 insertions(+), 15 deletions(-)

diff --git a/Documentation/devicetree/bindings/iio/adc/avia-hx711.yaml b/Documentation/devicetree/bindings/iio/adc/avia-hx711.yaml
index 9c57eb13f892..1ea60dff98d5 100644
--- a/Documentation/devicetree/bindings/iio/adc/avia-hx711.yaml
+++ b/Documentation/devicetree/bindings/iio/adc/avia-hx711.yaml
@@ -10,14 +10,9 @@ maintainers:
   - Andreas Klinger <ak@it-klinger.de>
 
 description: |
-  Bit-banging driver using two GPIOs:
-  - sck-gpio gives a clock to the sensor with 24 cycles for data retrieval
-    and up to 3 cycles for selection of the input channel and gain for the
-    next measurement
-  - dout-gpio is the sensor data the sensor responds to the clock
-
-  Specifications about the driver can be found at:
-  http://www.aviaic.com/ENProducts.aspx
+  The HX711 is a 24-bit ADC with selectable gain (32/64/128) and two
+  differential input channels. Channel A supports gain 64 and 128;
+  channel B supports gain 32.
 
 properties:
   compatible:
@@ -26,23 +21,23 @@ properties:
 
   sck-gpios:
     description:
-      Definition of the GPIO for the clock (output). In the datasheet it is
-      named PD_SCK
+      GPIO for the clock output (PD_SCK in the datasheet).
     maxItems: 1
 
   dout-gpios:
     description:
-      Definition of the GPIO for the data-out sent by the sensor in
-      response to the clock (input).
-      See Documentation/devicetree/bindings/gpio/gpio.txt for information
-      on how to specify a consumer gpio.
+      GPIO for the data output from the sensor (DOUT in the datasheet).
     maxItems: 1
 
   avdd-supply:
     description:
-      Definition of the regulator used as analog supply
+      Analog supply voltage (AVDD).
 
   clock-frequency:
+    description:
+      Controls the SCK bit-bang timing. The value is used to derive the
+      delay between SCK edges; keep the SCK high time below 60 us to
+      avoid triggering chip power-down mode.
     minimum: 20000
     maximum: 2500000
     default: 400000
-- 
2.43.0