[PATCH v3 1/4] dt-bindings: hwmon: (pmbus/max20830): add VOUT feedback resistor properties and complete examples

[Alexis Czezar Torreno <alexisczezar.torreno@analog.com>]

Add adi,vout-rfb1-ohms and adi,vout-rfb2-ohms properties to support
external voltage divider configuration for VOUT sensing. When the
desired output voltage is higher than VREF, a resistor divider (RFB1
and RFB2) is required to reach the intended value.

The properties use a dependency constraint to ensure both resistors
are specified together, or neither. This prevents misconfiguration
where only one resistor value is provided.

This patch also added missing entries in the examples.

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@oss.qualcomm.com>
Signed-off-by: Alexis Czezar Torreno <alexisczezar.torreno@analog.com>
---
 .../bindings/hwmon/pmbus/adi,max20830.yaml           | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
index 1625dd59417f1b3ca689a9c86ca266da913d1217..214adf1a3b9e9efdeca7db3bd7679c70656e9a7e 100644
--- a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
+++ b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
@@ -44,11 +44,26 @@ properties:
       GPIO connected to the power-good status output pin.
     maxItems: 1
 
+  adi,vout-rfb1-ohms:
+    description:
+      Top feedback resistor (RFB1) value in ohms for VOUT sensing divider.
+      When the desired output voltage is higher than VREF, a resistor divider
+      is required. VOUT = VREF × (1 + RFB1/RFB2)
+
+  adi,vout-rfb2-ohms:
+    description:
+      Bottom feedback resistor (RFB2) value in ohms for VOUT sensing divider.
+      Datasheet recommends that RFB2 does not exceed 2.5kΩ.
+
 required:
   - compatible
   - reg
   - vddh-supply
 
+dependencies:
+  adi,vout-rfb1-ohms: ['adi,vout-rfb2-ohms']
+  adi,vout-rfb2-ohms: ['adi,vout-rfb1-ohms']
+
 unevaluatedProperties: false
 
 examples:
@@ -61,6 +76,11 @@ examples:
             compatible = "adi,max20830";
             reg = <0x30>;
             vddh-supply = <&vddh>;
+            avdd-supply = <&avdd>;
+            ldoin-supply = <&ldoin>;
+            pwr-good-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>;
+            adi,vout-rfb1-ohms = <10000>;
+            adi,vout-rfb2-ohms = <2000>;
         };
     };
 ...

-- 
2.34.1