Re: [PATCH net-next v3 3/4] dt-bindings: net: x-powers: add AC200/AC300 EPHY packages

[sashiko-bot@kernel.org]

> The AC200 and AC300 contain compatible Fast Ethernet link PHYs which
> report the same Clause 22 identifier and use the same link-side register
> layout. Their package control paths differ: AC200 uses registers in its
> I2C MFD, while the AC300 control range is at a second Clause 22 address
> fixed at 16 plus the link address.
> 
> Describe both variants as Ethernet PHY packages. The package reg value is
> the link PHY base address and the child supplies the documented PHY ID,
> because the identification registers cannot be read until package setup
> has completed. The AC300 driver reaches its control range with the PHY
> package offset helpers. The AC200 package instead references its MFD.
> 
> Give fixed hardware variant-specific compatibles. Also provide an ACx00
> compatible for systems which can contain either package, with one packed
> NVMEM field containing calibration in bits 3 through 0, the AC300 selector
> in bit 8 and its low-calibration selector in bit 9. Such a description
> contains the potential resources for both backends; the driver consumes
> only those selected by the configuration field.
> 
> Describe the package clock, supply and optional xMII receive-clock
> inversion needed by some integrations. A fixed AC200 package may omit the
> NVMEM field and use its internal calibration copy. Limit AC300-capable link
> addresses to 0 through 7 so the control address remains in the documented
> range 16 through 23.
> 
> Signed-off-by: James Hilliard <james.hilliard1@gmail.com>

Sashiko has reviewed this patch and found no issues. It looks great!

-- 
Sashiko AI review · https://sashiko.dev/#/patchset/20260805-submit-acx00-of-dynamic-v1-v3-0-32c3210a6f25@gmail.com?part=3