messages from 2026-11-03 20:02:15 to 2026-11-03 23:32:00 UTC [more...]
[PATCH v3 0/5] bcma: support the BCM6362 integrated WLAN backplane
2026-11-03 23:31 UTC (6+ messages)
` [PATCH v3 1/5] dt-bindings: bus: add Broadcom BCM6362 WLAN AXI backplane
` [PATCH v3 2/5] bcma: scan: support big-endian backplanes
` [PATCH v3 3/5] bcma: scan: accept wrapper-less cores on wrapper-less backplanes
` [PATCH v3 4/5] bcma: add host driver for the BCM6362 integrated WLAN backplane
` [PATCH v3 5/5] MIPS: dts: bcm6362: add the "
[PATCH] arm64: dts: qcom: ipq6018: Drop undocumented 'qcom,ipq6018-wcss-pil'
2026-11-03 22:58 UTC
[PATCH] dt-bindings: display: imx: Document fsl,pcr
2026-11-03 22:55 UTC (2+ messages)
[PATCH v15 00/15] accel/rocket: RK3576 NPU (RKNN) enablement
2026-11-03 22:50 UTC (13+ messages)
` [PATCH v15 01/15] accel/rocket: request the core clocks by name
` [PATCH v15 02/15] accel/rocket: take the completion register writes under job_lock
` [PATCH v15 03/15] accel/rocket: wait for a running IRQ handler before resetting a core
` [PATCH v15 09/15] pmdomain: rockchip: add optional per-domain power-on settle delay
` [PATCH v15 10/15] pmdomain: rockchip: cycle an optional power-domain reset on power-on
[PATCH] dt-bindings: opp: Allow 'clock-latency' with dynamically populated OPPs
2026-11-03 22:45 UTC
[PATCH] dt-bindings: serial: 8250: Allow unconnected interrupts
2026-11-03 22:44 UTC
[PATCH] arm64: dts: realtek: Add RTD syscon compatibles
2026-11-03 22:43 UTC
[PATCH] arm64: dts: sprd: Add SC2731 FGU calibration resistance
2026-11-03 22:43 UTC
[PATCH] usb: host: ehci-xilinx-of: remove the driver
2026-11-03 22:18 UTC (2+ messages)
[PATCH net-next v2] dt-bindings: net: Convert snps,dwc-qos-ethernet to DT schema
2026-11-03 22:04 UTC
[PATCH net-next 0/4] net: pse-pd: realtek-pse-mcu: establish power management configuration
2026-11-03 22:03 UTC (5+ messages)
` [PATCH net-next 1/4] net: pse-pd: realtek-pse-mcu: ensure MCU does dynamic power management
` [PATCH net-next 2/4] dt-bindings: net: pse-pd: realtek,pse-mcu: add VMAIN supply
` [PATCH net-next 3/4] net: pse-pd: realtek-pse-mcu: configure global power budget
` [PATCH net-next 4/4] net: pse-pd: realtek-pse-mcu: avoid global disable on teardown
[PATCH v2 0/8] Add support for MIPS P8700
2026-11-03 21:59 UTC (16+ messages)
` [PATCH v2 2/8] dt-bindings: riscv: cpus: add gf,mips-p8700
` [PATCH v2 3/8] dt-bindings: riscv: Add MIPS Boston board compatible
` [PATCH v2 4/8] dt-bindings: interrupt-controller: Add MIPS P8700 APLIC
` [PATCH v2 5/8] dt-bindings: interrupt-controller: Add MIPS P8700 ACLINT MSWI
` [PATCH v2 6/8] dt-bindings: timer: Add MIPS P8700 ACLINT MTIMER
` [PATCH v2 7/8] riscv: dts: gf: Initial support for the P8700 Boston board
` [PATCH v2 8/8] riscv: defconfig: Enable GF SoCs
[PATCH] dt-bindings: Use hex unit address patterns
2026-11-03 21:57 UTC (2+ messages)
[PATCH 0/2] gpio: realtek-otto: Add RTL9311B support
2026-11-03 21:53 UTC (3+ messages)
` [PATCH 1/2] dt-bindings: gpio: realtek-otto: Add RTL9311B
` [PATCH 2/2] gpio: realtek-otto: Add RTL9311B support
[PATCH] dt-bindings: thermal: Use signed integers for coefficients
2026-11-03 21:43 UTC
[PATCH v7 00/12] serial: 8250_dw: share RX trigger setup and describe Allwinner UARTs
2026-11-03 21:40 UTC (13+ messages)
` [PATCH v7 01/12] serial: 8250_dw: select port setup through platform data
` [PATCH v7 02/12] serial: 8250: widen RX trigger byte counts to 16 bits
` [PATCH v7 03/12] serial: 8250: share the RX trigger conversion helper
` [PATCH v7 04/12] serial: 8250: expose RX trigger controls for custom callbacks
` [PATCH v7 05/12] serial: 8250_dw: derive RX trigger thresholds from the FIFO depth
` [PATCH v7 06/12] dt-bindings: serial: snps-dw-apb-uart: add Allwinner H616
` [PATCH v7 07/12] serial: 8250_dw: configure the Allwinner H616 UART
` [PATCH v7 08/12] arm64: dts: allwinner: h616: describe the UART integration
` [PATCH v7 09/12] dt-bindings: serial: snps-dw-apb-uart: add Allwinner A523
` [PATCH v7 10/12] serial: 8250_dw: discover Allwinner A523 FIFO depths through FCC
` [PATCH v7 11/12] arm64: dts: allwinner: a523: describe the UART integration
` [PATCH v7 12/12] serial: 8250_dw: configure RX trigger thresholds for Octeon
[PATCH v3 0/3] ARM: bcm: Enable CFE SMP on BCMBCA
2026-11-03 21:38 UTC (5+ messages)
` [PATCH v3 1/3] dt-bindings: arm: cpus: Add brcm,bca-smp enable method
[PATCH v3 00/18] pmdomain: st: ux500: Implement ux500 power domains
2026-11-03 21:08 UTC (5+ messages)
` [PATCH v3 15/18] dmaengine: ste_dma40: Use power domain for LCLA SRAM
[PATCH v3 1/2] dt-bindings: i2c: mt7621: Document an7581 compatible
2026-11-03 21:05 UTC (2+ messages)
` [PATCH v3 2/2] i2c: mt7621: limit SCL_STRETCH only to Mediatek SoC
[PATCH v6 0/3] Add support for CH1115 Controller
2026-11-03 21:05 UTC (5+ messages)
` [PATCH v6 1/3] dt-bindings: display: add Chipwealth CH1115 OLED Controller
` [PATCH v6 2/3] drm/ch1115: add support for Chipwealth CH1115 OLED controller
` [PATCH v6 3/3] MAINTAINERS: add entry for Chipwealth CH1115 OLED Controller
[PATCH v2 0/2] an8855: add MFD driver
2026-11-03 21:00 UTC (5+ messages)
` [PATCH v2 1/2] dt-bindings: mfd: Document support for Airoha AN8855 Switch SoC
` [PATCH v2 2/2] mfd: an8855: Add support for Airoha AN8855 Switch
[PATCH net-next 0/5] net: ethernet: adi: adin1110: Add OPEN Alliance TC6 support
2026-11-03 20:54 UTC (3+ messages)
[PATCH 0/2] usb: misc: usb251xb: add DT battery charging configuration
2026-11-03 20:52 UTC (5+ messages)
` [PATCH v2 "
` [PATCH v2 1/2] dt-bindings: usb: microchip,usb251xb: add battery-charging-enable property
` [PATCH v2 2/2] usb: misc: usb251xb: configure battery charging from DT
[PATCH v13 0/9] media: qcom: camss: CAMSS Offline Processing Engine support
2026-11-03 20:51 UTC (13+ messages)
` [PATCH v13 1/9] media: qcom: camss: Add V4L2 meta format for CAMSS ISP parameters
` [PATCH v13 2/9] dt-bindings: media: qcom: Add CAMSS Offline Processing Engine (OPE)
` [PATCH v13 3/9] dt-bindings: media: qcom,qcm2290-camss-ope: Document shikra compatible
` [PATCH v13 4/9] media: uapi: Add CAMSS ISP configuration definition
` [PATCH v13 5/9] media: Documentation: uapi: Add qcom-camss ISP params documentation
` [PATCH v13 6/9] media: qcom: camss: Add CAMSS Offline Processing Engine driver
` [PATCH v13 7/9] arm64: dts: qcom: agatti: Add OPE node
` [PATCH v13 8/9] arm64: dts: qcom: shikra: "
` [PATCH v13 9/9] arm64: defconfig: Enable Qualcomm CAMSS OPE driver
[PATCH net-next] dt-bindings: net: Convert snps,dwc-qos-ethernet to DT schema
2026-11-03 20:49 UTC (3+ messages)
[PATCH 0/4] ARM: dts: aspeed: x570d4u: devicetree fixes and cleanups
2026-11-03 20:43 UTC (6+ messages)
` [PATCH 1/4] ARM: dts: aspeed: x570d4u: Remove w83773g temperature sensor
` [PATCH 2/4] ARM: dts: aspeed: x570d4u: Fix fan tach channel assignments
` [PATCH 3/4] ARM: dts: aspeed: x570d4u: Give unique names to MAC address nvmem cells
` [PATCH 4/4] ARM: dts: aspeed: x570d4u: Add some GPIO line names
[PATCH v2 0/5] lx2160a: change the pad muxes through the RCW override
2026-11-03 20:20 UTC (4+ messages)
` [PATCH v2 1/5] dt-bindings: pinctrl: add the NXP LX2160A RCW pad mux
[PATCH v5 0/8] iio: imu: Add support for the ADI ADIS16607
2026-11-03 20:15 UTC (3+ messages)
` [PATCH v5 4/8] dt-bindings: iio: imu: Add bindings for "
[PATCH v5 0/2] phy: airoha: add support for AN7583 PCIe PHY driver
2026-11-03 20:03 UTC (3+ messages)
` [PATCH v5 2/2] phy: airoha: add support for AN7583 Gen3 "
[PATCH 0/2] Input: add support for the FocalTech FT3683G touchscreen
2026-11-03 20:02 UTC (3+ messages)
` [PATCH 2/2] Input: add FocalTech FT3683G touchscreen driver
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox