Re: [PATCH v2 2/9] dt-bindings: fsl,fpga-qixis-i2c: extend support to also cover the LX2160ARDB FPGA

[Frank Li <Frank.li@nxp.com>]

On Mon, Sep 15, 2025 at 03:23:47PM +0300, Ioana Ciornei wrote:

subject:
dt-bindings: fsl,fpga-qixis-i2c: add support for LX2160ARDB FPGA

> Extend the list of supported compatible strings with fsl,lx2160ardb-fpga.
>
> Since the register map exposed by the LX2160ARDB's FPGA also contains
> two GPIO controllers, accept the necessary GPIO pattern property.
> At the same time, add the #address-cells and #size-cells properties as
> valid ones so that the child nodes of the fsl,lx2160ardb-fpga node are
> addressable.
>
> This is needed because when defining child devices such as the GPIO
> controller described in the added example, the child device needs a the
> reg property to properly identify its register location.

These are neccesary because reg of child gpio controller nodes is in I2C
device's address space.

need empty line here.

> Impose this restriction for the new compatible through an if-statement.
>
> Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
> ---
> Changes in v2:
> - Enforce a unit address on the child gpios nodes (remove the ?)
> - Enforce the use of unit addresses by having #address-size and
>   #size-cells only for the newly added fsl,lx2160ardb-fpga compatible
>
>  .../bindings/board/fsl,fpga-qixis-i2c.yaml    | 47 +++++++++++++++++++
>  1 file changed, 47 insertions(+)
>
...

>
> +allOf:
> +  - if:
> +      properties:
> +        compatible:
> +          contains:
> +            enum:
> +              - fsl,lx2160ardb-fpga
> +    then:
> +      required:
> +        - "#address-cells"
> +        - "#size-cells"
> +
       else:
         properties:
           '#address-cells': false
           'size-cells': false

Frank
>  additionalProperties: false
>
>  examples:
> @@ -68,3 +91,27 @@ examples:
>          };
>      };
>
> +  - |
> +    i2c {
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        board-control@66 {
> +            compatible = "fsl,lx2160ardb-fpga";
> +            reg = <0x66>;
> +            #address-cells = <1>;
> +            #size-cells = <0>;
> +
> +            gpio@19 {
> +                compatible = "fsl,lx2160ardb-fpga-gpio-sfp";
> +                reg = <0x19>;
> +                gpio-controller;
> +                #gpio-cells = <2>;
> +                gpio-line-names =
> +                    "SFP2_TX_EN", "",
> +                    "", "",
> +                    "SFP2_RX_LOS", "SFP2_TX_FAULT",
> +                    "", "SFP2_MOD_ABS";
> +            };
> +        };
> +    };
> --
> 2.25.1
>