Re: [PATCH net-next v3 2/3] dt-bindings: net: wiznet,w5100: add link-gpios

["Arthur Crépin Leblond" <arthur@marmottus.net>]

On Mon, Aug 10, 2026 at 09:59:18AM +0200, Krzysztof Kozlowski wrote:
>On 10/08/2026 09:53, Arnd Bergmann wrote:
>> On Mon, Aug 10, 2026, at 09:43, Krzysztof Kozlowski wrote:
>>> On Thu, Aug 06, 2026 at 05:00:01PM +0200, Arthur Crépin Leblond wrote:
>>>>
>>>> +  link-gpios:
>>>> +    description:
>>>> +      An optional GPIO line that can be wired to the LINKLED pin of the w5500
>>>> +      as an interrupt to detect link status changes.
>>>
>>> The message is confusing. If you describe it from the host (system point
>>> of view), then interrupts are not GPIOs but "interrupts".
>>>
>>> But maybe this is OUT GPIO from the system to the device?
>>
>> From the device point of view, it's an LED output, but from the
>> system side we should describe it as an IRQ_TYPE_EDGE_BOTH
>> "interrupts" property rather than a gpio line.
>
>Then probably we should list all four other pins as well (speed, duplex
>and active).
>
>Best regards,
>Krzysztof

We use this line to detect a link change but don't read its value in
the interrupt handler, we read the i2c PHYCFGR register to get the
link status.

Arthur