Devicetree
 help / color / mirror / Atom feed
* [PATCH 0/3] pinctrl: airoha: add EcoNet EN7528 pin controller support
@ 2026-08-09  8:04 Ahmed Naseef
  2026-08-09  8:04 ` [PATCH 1/3] pinctrl: airoha: limit GPIO interrupts to interrupt-capable pins Ahmed Naseef
                   ` (3 more replies)
  0 siblings, 4 replies; 8+ messages in thread
From: Ahmed Naseef @ 2026-08-09  8:04 UTC (permalink / raw)
  To: linux-gpio
  Cc: Ahmed Naseef, Benjamin Larsson, Christian Marangi, Conor Dooley,
	Krzysztof Kozlowski, Linus Walleij, Lorenzo Bianconi,
	Mikhail Kshevetskiy, Rob Herring, devicetree, linux-kernel,
	linux-mediatek

The EcoNet EN7528 is a MIPS SoC that uses the same pin controller and GPIO
IP as the Airoha SoCs, so it reuses the shared driver code introduced by
the split into per-SoC drivers. Its register layout differs from every
existing variant though: all IOMUX mode bits live in a single CHIP SCU
register plus a few spill-over bits in IOMUX Control 3, EJTAG has its own
enable register, and every pin configuration register is at a different
offset than on EN7523.

It also differs in a way the shared code did not model: only GPIO0-GPIO15
are wired to the interrupt controller, while the driver assumed all
AIROHA_NUM_PINS GPIOs could raise an interrupt. Patch 1 adds a
num_irq_pins field to the per-SoC match data to describe that, bounds the
interrupt callbacks and handler with it, and feeds it to gpiolib through
gpio_irq_chip::init_valid_mask so gpiod_to_irq() fails up front for a pin
that can never be an interrupt source. All existing SoCs pass
AIROHA_NUM_PINS and are unaffected.

Patch 2 documents the binding, patch 3 adds the driver.

The series is based on linux-pinctrl/for-next, as it depends on the
per-SoC driver split and on the CHIP SCU lookup by "airoha,chip-scu"
phandle that landed there.

Tested on a DASAN H660GM-A (EN7528, Airtel), booting OpenWrt.

Ahmed Naseef (2):
  pinctrl: airoha: limit GPIO interrupts to interrupt-capable pins
  dt-bindings: pinctrl: Add EcoNet EN7528 pin controller

Benjamin Larsson (1):
  pinctrl: airoha: add support of en7528 SoC

 .../pinctrl/econet,en7528-pinctrl.yaml        |  190 +++
 drivers/pinctrl/airoha/Kconfig                |   15 +-
 drivers/pinctrl/airoha/Makefile               |    1 +
 drivers/pinctrl/airoha/airoha-common.h        |    3 +
 drivers/pinctrl/airoha/pinctrl-airoha.c       |   33 +-
 drivers/pinctrl/airoha/pinctrl-an7563.c       |    1 +
 drivers/pinctrl/airoha/pinctrl-an7581.c       |    1 +
 drivers/pinctrl/airoha/pinctrl-an7583.c       |    1 +
 drivers/pinctrl/airoha/pinctrl-en7523.c       |    1 +
 drivers/pinctrl/airoha/pinctrl-en7528.c       | 1204 +++++++++++++++++
 10 files changed, 1443 insertions(+), 7 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/pinctrl/econet,en7528-pinctrl.yaml
 create mode 100644 drivers/pinctrl/airoha/pinctrl-en7528.c


base-commit: 87e787e591a82b9b324aa0968795b256f789d287
-- 
2.34.1


^ permalink raw reply	[flat|nested] 8+ messages in thread

end of thread, other threads:[~2026-08-10  7:27 UTC | newest]

Thread overview: 8+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2026-08-09  8:04 [PATCH 0/3] pinctrl: airoha: add EcoNet EN7528 pin controller support Ahmed Naseef
2026-08-09  8:04 ` [PATCH 1/3] pinctrl: airoha: limit GPIO interrupts to interrupt-capable pins Ahmed Naseef
2026-08-09  8:18   ` sashiko-bot
2026-08-09  8:04 ` [PATCH 2/3] dt-bindings: pinctrl: Add EcoNet EN7528 pin controller Ahmed Naseef
2026-08-09  8:15   ` sashiko-bot
2026-08-09  8:05 ` [PATCH 3/3] pinctrl: airoha: add support of en7528 SoC Ahmed Naseef
2026-08-10  7:23 ` [PATCH 0/3] pinctrl: airoha: add EcoNet EN7528 pin controller support Linus Walleij
2026-08-10  7:27   ` Christian Marangi (Ansuel)

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox