TCP/IP via digi

TCP/IP via digi

[Aleksandar Ilic]

Hello,
I wonder is it possible to establish tcp/ip over ax25 connection via an TheNet 
X-1J4 digipeater? Direct connection between my two machines works, but the 
gateway isn't reachable direct - only via digi.
I searched list archive, but found only question, not the answer...

regards, Alek
-- 
  73 de YU1IS  -=-  ICQ# 62419462

Re: TCP/IP via digi

[Aleksandar Ilic]

Paul, Richard,

thanks for an express answer.
I'll give a try and announce the results.

Alek.
-- 
  73 de YU1IS  -=-  ICQ# 62419462

Re: TCP/IP via digi

[Aleksandar Ilic]

Hello Paul,

> get the sysop of the x1j4 node to enable the IP stack on the
> node then you can use it as an ip router.

I've checked IP settings at x-1j4 node, and you was right. IP adress is in 
wrong range, and no route is set. The bizzare thing is, that people from 
radio-club who are maintaining digi haven't a clue about sysop password. They 
will try to find when and who programmed the EPROM's for them - Hi !
In between, is it any "factory-default" password for TheNet? I'm very much 
assured it is left as is. Would you look at your documentation once again?

It is all about 4N1ZNX gateway (of which I am co-sysop), and 4N1ZNI-6 
digipeater on near hill. Those two are covering Nis area here in east Serbia 
since last autumn very solid.

regards,
Alek
-- 
  73 de YU1IS  -=-  ICQ# 62419462