ax25 route question.

ax25 route question.

[John Ronan]

[-- Attachment #1: Type: text/plain, Size: 469 bytes --]

Could someone give an example of how ax25 routes are supposed to  
work? I've been trying to figure this out.

My understanding (which could be wrong) was that If I did

axparms -route add myport calla digia

that if I did
axcall calla

that the outgoing connect would be directed through digia

Is my understanding incorrect?

Regards
de John
EI7IG

--
John Ronan <jronan@tssg.org>, +353-51-302938
Telecommunications Software &  Systems Group,  http://www.tssg.org




[-- Attachment #2: smime.p7s --]
[-- Type: application/pkcs7-signature, Size: 2204 bytes --]

Re: ax25 route question.

[Pidoux]

Hi John,

I did not see any reply to your question.
Personnally I don't know if the example you gave is correct and would work.
But you may have perfomed some tests already ?
I would say that, as far as AX25 routing is concerned, there are a number of possibilities, using higher level routing 
facilities, such as node, flexnet or FPAC (based on ROSE network protocol).
I am more familiar with ROSE/FPAC that uses a very efficient routing algorithm and white pages at the cost of only three 
more bytes per AX25 frames.
You could find some documentation about FPAC here

http://ftp.f6fbb.org/fpac/doc/FPAC-HOWTO.html#toc1
http://rose.fpac.free.fr/MINI-HOWTO/


73 de Bernard, f6bvp
http://f6bvp.org



John Ronan wrote :
> Could someone give an example of how ax25 routes are supposed to work? 
> I've been trying to figure this out.
> 
> My understanding (which could be wrong) was that If I did
> 
> axparms -route add myport calla digia
> 
> that if I did
> axcall calla
> 
> that the outgoing connect would be directed through digia
> 
> Is my understanding incorrect?
> 
> Regards
> de John
> EI7IG
> 
> -- 
> John Ronan <jronan@tssg.org>, +353-51-302938
> Telecommunications Software &  Systems Group,  http://www.tssg.org
> 
> 
>