From: Dmitry Osipenko <dmitry.osipenko@collabora.com>
To: Benjamin Bara <bbara93@gmail.com>, Wolfram Sang <wsa@kernel.org>,
Lee Jones <lee@kernel.org>,
rafael.j.wysocki@intel.com
Cc: peterz@infradead.org, jonathanh@nvidia.com,
richard.leitner@linux.dev, treding@nvidia.com,
linux-kernel@vger.kernel.org, linux-i2c@vger.kernel.org,
linux-tegra@vger.kernel.org,
Benjamin Bara <benjamin.bara@skidata.com>
Subject: Re: [PATCH v6 5/5] mfd: tps6586x: register restart handler
Date: Wed, 12 Jul 2023 06:40:43 +0300 [thread overview]
Message-ID: <6522d921-ca35-4359-cc10-645e6278422e@collabora.com> (raw)
In-Reply-To: <7eddaf8c-ab04-7670-fc45-15f0fce5eff2@collabora.com>
On 5/18/23 14:48, Dmitry Osipenko wrote:
> On 5/9/23 22:03, Benjamin Bara wrote:
>> From: Benjamin Bara <benjamin.bara@skidata.com>
>>
>> There are a couple of boards which use a tps6586x as
>> "ti,system-power-controller", e.g. the tegra20-tamonten.dtsi.
>> For these, the only registered restart handler is the warm reboot via
>> tegra's PMC. As the bootloader of the tegra20 requires the VDE, it must
>> be ensured that VDE is enabled (which is the case after a cold reboot).
>> For the "normal reboot", this is basically the case since 8f0c714ad9be.
>> However, this workaround is not executed in case of an emergency restart.
>> In case of an emergency restart, the system now simply hangs in the
>> bootloader, as VDE is not enabled (because it is not used).
>>
>> The TPS658629-Q1 provides a SOFT RST bit in the SUPPLYENE reg to request
>> a (cold) reboot, which takes at least 20ms (as the data sheet states).
>> This avoids the hang-up.
>>
>> Tested on a TPS658640.
>>
>> Signed-off-by: Benjamin Bara <benjamin.bara@skidata.com>
>> ---
>> drivers/mfd/tps6586x.c | 26 ++++++++++++++++++++++++++
>> 1 file changed, 26 insertions(+)
>>
>> diff --git a/drivers/mfd/tps6586x.c b/drivers/mfd/tps6586x.c
>> index b12c9e18970a..3b8faa058e59 100644
>> --- a/drivers/mfd/tps6586x.c
>> +++ b/drivers/mfd/tps6586x.c
>> @@ -30,6 +30,7 @@
>> #include <linux/mfd/tps6586x.h>
>>
>> #define TPS6586X_SUPPLYENE 0x14
>> +#define SOFT_RST_BIT BIT(0)
>> #define EXITSLREQ_BIT BIT(1)
>> #define SLEEP_MODE_BIT BIT(3)
>>
>> @@ -475,6 +476,24 @@ static int tps6586x_power_off_handler(struct sys_off_data *data)
>> return notifier_from_errno(-ETIME);
>> }
>>
>> +static int tps6586x_restart_handler(struct sys_off_data *data)
>> +{
>> + int ret;
>> +
>> + /* TPS6586X only provides a hard/cold reboot, skip others. */
>> + if (data->mode != REBOOT_UNDEFINED && data->mode != REBOOT_COLD &&
>> + data->mode != REBOOT_HARD)
>> + return NOTIFY_DONE;
>
> Not sure whether it's worthwhile to care about the reboot mode. If we
> would really care, then the supported modes should be a part of sys-off
> handler definition. Maybe Rafael could comment on it.
>
> Otherwise looks good.
>
> Reviewed-by: Dmitry Osipenko <dmitry.osipenko@collabora.com>
Benjamin, could you please add acks and review tags to the commits and
send v7? I'd also suggest to drop the "data->mode" checks unless there
is a good practical reason to keep them. There are no other drivers in
kernel that do such checks.
--
Best regards,
Dmitry
prev parent reply other threads:[~2023-07-12 3:40 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-05-09 19:02 [PATCH v6 0/5] mfd: tps6586x: register restart handler Benjamin Bara
2023-05-09 19:02 ` [PATCH v6 1/5] kernel/reboot: emergency_restart: set correct system_state Benjamin Bara
2023-05-18 11:34 ` Dmitry Osipenko
2023-06-15 0:06 ` Nishanth Menon
2023-06-15 13:21 ` Francesco Dolcini
2023-06-15 14:39 ` Nishanth Menon
2023-05-09 19:03 ` [PATCH v6 2/5] i2c: core: run atomic i2c xfer when !preemptible Benjamin Bara
2023-05-18 11:34 ` Dmitry Osipenko
2023-06-15 0:05 ` Nishanth Menon
2023-05-09 19:03 ` [PATCH v6 3/5] kernel/reboot: add device to sys_off_handler Benjamin Bara
2023-05-18 11:39 ` Dmitry Osipenko
2023-05-09 19:03 ` [PATCH v6 4/5] mfd: tps6586x: use devm-based power off handler Benjamin Bara
2023-05-18 9:43 ` Lee Jones
2023-05-18 11:15 ` Benjamin Bara
2023-05-18 11:40 ` Dmitry Osipenko
2023-05-09 19:03 ` [PATCH v6 5/5] mfd: tps6586x: register restart handler Benjamin Bara
2023-05-18 9:44 ` Lee Jones
2023-05-18 11:48 ` Dmitry Osipenko
2023-07-12 3:40 ` Dmitry Osipenko [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=6522d921-ca35-4359-cc10-645e6278422e@collabora.com \
--to=dmitry.osipenko@collabora.com \
--cc=bbara93@gmail.com \
--cc=benjamin.bara@skidata.com \
--cc=jonathanh@nvidia.com \
--cc=lee@kernel.org \
--cc=linux-i2c@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-tegra@vger.kernel.org \
--cc=peterz@infradead.org \
--cc=rafael.j.wysocki@intel.com \
--cc=richard.leitner@linux.dev \
--cc=treding@nvidia.com \
--cc=wsa@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox