messages from 2024-01-15 16:16:29 to 2024-01-29 22:48:35 UTC [more...]
[PATCH v2 00/15] Add suspend to ram support for PCIe on J7200
2024-01-29 22:48 UTC (36+ messages)
` [PATCH v2 01/15] gpio: pca953x: move suspend()/resume() to suspend_noirq()/resume_noirq()
` [PATCH v2 02/15] pinctrl: pinctrl-single: move suspend()/resume() callbacks to noirq
` [PATCH v2 03/15] i2c: omap: wakeup the controller during suspend() callback
` [PATCH v2 04/15] mux: add mux_chip_resume() function
` [PATCH v2 05/15] mux: mmio: add resume support
` [PATCH v2 06/15] phy: ti: phy-j721e-wiz: make wiz_clock_init callable multiple times
` [PATCH v2 07/15] phy: ti: phy-j721e-wiz: add resume support
` [PATCH v2 08/15] phy: cadence-torrent: extract calls to clk_get from cdns_torrent_clk
` [PATCH v2 09/15] phy: cadence-torrent: register resets even if the phy is already configured
` [PATCH v2 10/15] phy: cadence-torrent: add already_configured to struct cdns_torrent_phy
` [PATCH v2 11/15] phy: cadence-torrent: remove noop_ops phy operations
` [PATCH v2 12/15] phy: cadence-torrent: add suspend and resume support
` [PATCH v2 13/15] PCI: cadence: add resume support to cdns_pcie_host_setup()
` [PATCH v2 14/15] PCI: j721e: add reset GPIO to struct j721e_pcie
` [PATCH v2 15/15] PCI: j721e: add suspend and resume support
[PATCH v2] hwmon: Add driver for MPS MPQ8785 Synchronous Step-Down Converter
2024-01-29 15:49 UTC (3+ messages)
[PATCH 1/1] i2c: i2c-qcom-geni: Correct I2C TRE sequence
2024-01-29 6:15 UTC (3+ messages)
[V2] i2c: i2c-qcom-geni: Correct I2C TRE sequence
2024-01-29 6:10 UTC
[PATCH AUTOSEL 6.1 27/27] i2c: rk3x: Adjust mask/value offset for i2c2 on rv1126
2024-01-28 23:19 UTC (2+ messages)
[PATCH 0/8] i2c: i801: collection of further improvements / refactorings
2024-01-28 21:38 UTC (2+ messages)
[PATCH v1] hwmon: Add driver for MPS MPQ8785 Synchronous Step-Down Converter
2024-01-28 17:13 UTC (3+ messages)
[PATCH AUTOSEL 6.6 31/31] i2c: rk3x: Adjust mask/value offset for i2c2 on rv1126
2024-01-28 16:13 UTC
[PATCH AUTOSEL 6.7 39/39] i2c: rk3x: Adjust mask/value offset for i2c2 on rv1126
2024-01-28 16:10 UTC
[PATCH net-next] mlxsw: remove I2C_CLASS_HWMON from drivers w/o detect and address_list
2024-01-28 14:18 UTC (2+ messages)
[PATCH 00/14] Add suspend to ram support for PCIe on J7200
2024-01-28 0:12 UTC (37+ messages)
` [PATCH 01/14] gpio: pca953x: move suspend/resume to suspend_noirq/resume_noirq
` [PATCH 02/14] pinctrl: pinctrl-single: "
` [PATCH 03/14] i2c: omap: wakeup the controller during suspend callback
` [PATCH 04/14] mux: mmio: Add resume support
` [PATCH 05/14] phy: ti: phy-j721e-wiz: make wiz_clock_init callable multiple times
` [PATCH 11/14] phy: cadence-torrent: add suspend and resume support
` [PATCH 12/14] PCI: cadence: add resume support to cdns_pcie_host_setup()
` [PATCH 13/14] PCI: j721e: move reset GPIO to device struct
` [PATCH 14/14] PCI: j721e: add suspend and resume support
[PATCH] Input: bma150: remove I2C_CLASS_HWMON from drivers w/o detect and address_list
2024-01-27 15:18 UTC
[PATCH] ipmi: ipmb: Remove I2C_CLASS_HWMON from drivers w/o detect and address_list
2024-01-27 15:15 UTC
[PATCH] media: ddbridge: Remove unused class-based I2C autoprobing code
2024-01-27 7:12 UTC (2+ messages)
[PATCH v2 0/4] i2c: Support i2c_register_spd() on multiplexed bus segments
2024-01-26 21:15 UTC (2+ messages)
[PATCH] MAINTAINERS: Update i2c host drivers repository
2024-01-26 8:54 UTC (2+ messages)
[PATCH] i2c: imx: move to generic GPIO recovery
2024-01-26 7:43 UTC (4+ messages)
[PATCH v2 RESEND] i2c: cadence: Add system suspend and resume PM support
2024-01-25 15:30 UTC (7+ messages)
[RESEND PATCH v5 1/2] dt-bindings: i2c: pca954x: Add custom properties for MAX7357
2024-01-25 11:58 UTC (5+ messages)
[PATCH 1/2] dt-bindings: i2c: mux: i2c-demux-pinctrl: Drop i2c-mux.yaml reference
2024-01-24 19:05 UTC (2+ messages)
` [PATCH 2/2] dt-bindings: i2c: mux: i2c-demux-pinctrl: Define "i2c-parent" constraints
[PATCH v4 0/8] GS101 Oriole: CMU_PERIC0 support and USI updates
2024-01-23 9:54 UTC (29+ messages)
` [PATCH v4 1/8] dt-bindings: clock: google,gs101-clock: add PERIC0 clock management unit
` (subset) "
` [PATCH v4 2/8] dt-bindings: i2c: exynos5: add google,gs101-hsi2c compatible
` (subset) "
` [PATCH v4 3/8] clk: samsung: gs101: add support for cmu_peric0
` [PATCH v4 4/8] arm64: dts: exynos: gs101: remove reg-io-width from serial
` (subset) "
` [PATCH v4 5/8] arm64: dts: exynos: gs101: enable cmu-peric0 clock controller
` (subset) "
` [PATCH v4 6/8] arm64: dts: exynos: gs101: update USI UART to use peric0 clocks
` (subset) "
` [PATCH v4 7/8] arm64: dts: exynos: gs101: define USI8 with I2C configuration
` (subset) "
` [PATCH v4 8/8] arm64: dts: exynos: gs101: enable eeprom on gs101-oriole
` (subset) "
[PATCH]i2c: hisi: Clear the interrupt status and optimize writing limitation
2024-01-23 8:02 UTC (3+ messages)
` [PATCH 1/2] i2c: hisi: Optimized the value setting of maxwrite limit to fifo depth - 1
` [PATCH 2/2] i2c: hisi: Add clearing tx aempty interrupt operation
[PATCH] MAINTAINERS: Drop my "+dt" sub-address
2024-01-22 21:32 UTC (2+ messages)
[PATCH 00/20] remove I2C_CLASS_DDC support
2024-01-22 15:31 UTC (3+ messages)
` [PATCH v3 11/20] drivers/gpu/drm/bridge/synopsys/dw-hdmi.c: "
Dell XPS 13 9360: DMAR errors `DRHD: handling fault status reg 2` and `[INTR-REMAP] Request device [f0:1f.0] fault index 0x0`
2024-01-22 13:22 UTC (2+ messages)
[PATCH v3 0/5] reset: gpio: ASoC: shared GPIO resets
2024-01-22 13:14 UTC (17+ messages)
` [PATCH v3 2/5] reset: Instantiate reset GPIO controller for shared reset-gpios
` [PATCH v3 3/5] ASoC: dt-bindings: qcom,wsa8840: Add reset-gpios for shared line
` [PATCH v3 5/5] i2c: muxes: pca954x: Allow sharing reset GPIO
[PATCH v1 1/2] i2c: designware: constify abort_sources
2024-01-22 9:44 UTC (3+ messages)
` [PATCH v1 2/2] i2c: designware: constify regmap_config
[PATCH] dt-bindings: i2c: imx-lpi2c: add i.MX95 LPI2C
2024-01-22 9:33 UTC (2+ messages)
[PATCH v4 00/24] Improve IRQ wake capability reporting and update the cros_ec driver to use it
2024-01-22 9:14 UTC (2+ messages)
[PATCH v7 0/6] i2c: add zhaoxin i2c controller driver
2024-01-21 23:56 UTC (5+ messages)
` [PATCH v7 1/6] i2c: wmt: create wmt_i2c_init for general init
[PATCH v9 00/13] Introduce STM32 Firewall framework
2024-01-19 22:06 UTC (3+ messages)
` [PATCH v9 02/13] dt-bindings: treewide: add access-controllers description
[PATCH v2 1/1] i2c: lpi2c: Avoid calling clk_get_rate during transfer
2024-01-19 7:48 UTC (2+ messages)
[PULL REQUEST] i2c-for-6.8-rc1-rebased
2024-01-19 2:40 UTC (2+ messages)
[PATCH 1/1] i2c: lpi2c: Avoid calling clk_get_rate during transfer
2024-01-19 0:08 UTC (5+ messages)
[PULL REQUEST] i2c-for-6.8-rc1-fixed
2024-01-18 5:52 UTC (4+ messages)
[PATCH] i2c: cadence: Avoid fifo clear after start
2024-01-17 21:05 UTC (4+ messages)
[PULL REQUEST] i2c-for-6.8-rc1
2024-01-17 21:00 UTC (3+ messages)
[PATCH v3 00/12] GS101 Oriole: CMU_PERIC0 support and USI updates
2024-01-17 16:12 UTC (24+ messages)
` [PATCH v3 01/12] dt-bindings: clock: google,gs101-clock: add PERIC0 clock management unit
` [PATCH v3 03/12] dt-bindings: serial: samsung: do not allow reg-io-width for gs101
` [PATCH v3 04/12] tty: serial: samsung: prepare for different IO types
` [PATCH v3 05/12] tty: serial: samsung: set UPIO_MEM32 iotype for gs101
` [PATCH v3 06/12] tty: serial: samsung: add gs101 earlycon support
` [PATCH v3 07/12] clk: samsung: gs101: add support for cmu_peric0
` [PATCH v3 08/12] arm64: dts: exynos: gs101: remove reg-io-width from serial
` [PATCH v3 10/12] arm64: dts: exynos: gs101: update USI UART to use peric0 clocks
` [PATCH v3 11/12] arm64: dts: exynos: gs101: define USI8 with I2C configuration
[PATCH/RFC] i2c: sh_mobile: Switch R-Mobile A1/APE6 and SH-Mobile AG5 to new frequency calculation
2024-01-17 14:34 UTC (2+ messages)
[PATCH v8 1/1] i2c: lpi2c: use clk notifier for rate changes
2024-01-17 7:11 UTC (4+ messages)
[PATCH] i2c: designware: Revert recent changes to i2c_dw_probe_lock_support()
2024-01-16 8:15 UTC (6+ messages)
[PATCH] i2c: octeon: Add block-mode r/w
2024-01-16 1:38 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox