From: Frank Li <Frank.Li@nxp.com>
To: Alexandre Belloni <alexandre.belloni@bootlin.com>,
Boris Brezillon <boris.brezillon@collabora.com>,
Parshuram Thombare <pthombar@cadence.com>,
Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
Boris Brezillon <bbrezillon@kernel.org>,
Arnd Bergmann <arnd@arndb.de>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Conor Culhane <conor.culhane@silvaco.com>
Cc: linux-i3c@lists.infradead.org, linux-kernel@vger.kernel.org,
imx@lists.linux.dev, Frank Li <Frank.Li@nxp.com>
Subject: [PATCH v3 09/11] i3c: master: svc: use spinlock_saveirq at svc_i3c_master_ibi_work()
Date: Mon, 19 Aug 2024 12:02:03 -0400 [thread overview]
Message-ID: <20240819-i3c_fix-v3-9-7d69f7b0a05e@nxp.com> (raw)
In-Reply-To: <20240819-i3c_fix-v3-0-7d69f7b0a05e@nxp.com>
According to I3C spec ver 1.1, 09-Jun-2021, section 5.1.2.5:
The I3C Controller shall hold SCL Low while the Bus is in I3C/I2C Transfer,
ACK/NACK Phase. But maximum stall time is 100us. We have to disable irq and
schedule during whole I3C transaction, otherwise, I3C bus timeout will
happen if any irq or schedule happen during transaction.
Replace mutex with spinlock_saveirq() to make sure finish whole i3c
transaction without stall SCL more than 100us.
Signed-off-by: Frank Li <Frank.Li@nxp.com>
---
drivers/i3c/master/svc-i3c-master.c | 14 +++++++++++---
1 file changed, 11 insertions(+), 3 deletions(-)
diff --git a/drivers/i3c/master/svc-i3c-master.c b/drivers/i3c/master/svc-i3c-master.c
index 161ccd824443b..fbb6cef405577 100644
--- a/drivers/i3c/master/svc-i3c-master.c
+++ b/drivers/i3c/master/svc-i3c-master.c
@@ -432,7 +432,16 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
u32 status, val;
int ret;
- mutex_lock(&master->lock);
+ /*
+ * According to I3C spec ver 1.1, 09-Jun-2021, section 5.1.2.5:
+ *
+ * The I3C Controller shall hold SCL Low while the Bus is in I3C/I2C Transfer, ACK/NACK
+ * Phase. But maximum stall time is 100us. We have to disable irq and schedule during whole
+ * I3C transaction, otherwise, I3C bus timeout will happen if any irq or schedule happen
+ * between transaction..
+ */
+ guard(spinlock_irqsave)(&master->xferqueue.lock);
+
/*
* IBIWON may be set before SVC_I3C_MCTRL_REQUEST_AUTO_IBI, causing
* readl_relaxed_poll_timeout() to return immediately. Consequently,
@@ -452,7 +461,7 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
master->regs + SVC_I3C_MCTRL);
/* Wait for IBIWON, should take approximately 100us */
- ret = readl_relaxed_poll_timeout(master->regs + SVC_I3C_MSTATUS, val,
+ ret = readl_relaxed_poll_timeout_atomic(master->regs + SVC_I3C_MSTATUS, val,
SVC_I3C_MSTATUS_IBIWON(val), 0, 1000);
if (ret) {
dev_err(master->dev, "Timeout when polling for IBIWON\n");
@@ -525,7 +534,6 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
reenable_ibis:
svc_i3c_master_enable_interrupts(master, SVC_I3C_MINT_SLVSTART);
- mutex_unlock(&master->lock);
}
static irqreturn_t svc_i3c_master_irq_handler(int irq, void *dev_id)
--
2.34.1
--
linux-i3c mailing list
linux-i3c@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-i3c
next prev parent reply other threads:[~2024-08-19 16:03 UTC|newest]
Thread overview: 39+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-19 16:01 [PATCH v3 00/11] i3c: master: some fix and improvemnt for hotjoin Frank Li
2024-08-19 16:01 ` [PATCH v3 01/11] i3c: master: Remove i3c_dev_disable_ibi_locked(olddev) on device hotjoin Frank Li
2024-08-20 1:34 ` Stanley Chu
2024-08-20 14:45 ` Frank Li
2024-08-23 15:53 ` Miquel Raynal
2024-08-19 16:01 ` [PATCH v3 02/11] i3c: master: Replace hard code 2 with macro I3C_ADDR_SLOT_BITS Frank Li
2024-08-23 15:55 ` Miquel Raynal
2024-08-23 17:57 ` Frank Li
2024-08-26 8:05 ` Miquel Raynal
2024-08-19 16:01 ` [PATCH v3 03/11] i3c: master: Extend address status bit to 4 and add I3C_ADDR_SLOT_EXT_INIT Frank Li
2024-08-23 16:04 ` Miquel Raynal
2024-08-23 17:55 ` Frank Li
2024-08-26 8:04 ` Miquel Raynal
2024-08-26 15:56 ` Frank Li
2024-08-26 16:49 ` Miquel Raynal
2024-08-26 18:55 ` Frank Li
2024-09-02 14:12 ` Miquel Raynal
2024-09-02 18:20 ` Frank Li
2024-09-03 13:00 ` Miquel Raynal
2024-09-03 15:06 ` Frank Li
2024-09-09 20:01 ` Frank Li
2024-09-16 15:14 ` Frank Li
2024-08-19 16:01 ` [PATCH v3 04/11] i3c: master: Fix dynamic address leak when 'assigned-address' is present Frank Li
2024-08-19 16:01 ` [PATCH v3 05/11] i3c: master: Fix miss free init_dyn_addr at i3c_master_put_i3c_addrs() Frank Li
2024-08-23 16:07 ` Miquel Raynal
2024-08-19 16:02 ` [PATCH v3 06/11] i3c: master: svc: use repeat start when IBI WIN happens Frank Li
2024-08-23 16:09 ` Miquel Raynal
2024-08-19 16:02 ` [PATCH v3 07/11] i3c: master: svc: manually emit NACK/ACK for hotjoin Frank Li
2024-08-23 16:10 ` Miquel Raynal
2024-08-19 16:02 ` [PATCH v3 08/11] i3c: master: svc: need check IBIWON for dynamtica address assign Frank Li
2024-08-23 16:12 ` Miquel Raynal
2024-08-19 16:02 ` Frank Li [this message]
2024-08-23 16:19 ` [PATCH v3 09/11] i3c: master: svc: use spinlock_saveirq at svc_i3c_master_ibi_work() Miquel Raynal
2024-08-23 16:53 ` Frank Li
2024-08-19 16:02 ` [PATCH v3 10/11] i3c: master: svc: wait for Manual ACK/NACK Done before next step Frank Li
2024-08-23 16:22 ` Miquel Raynal
2024-08-23 16:45 ` Frank Li
2024-08-19 16:02 ` [PATCH v3 11/11] i3c: master: svc: fix possible assignment of the same address to two devices Frank Li
2024-08-23 16:24 ` Miquel Raynal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240819-i3c_fix-v3-9-7d69f7b0a05e@nxp.com \
--to=frank.li@nxp.com \
--cc=alexandre.belloni@bootlin.com \
--cc=arnd@arndb.de \
--cc=bbrezillon@kernel.org \
--cc=boris.brezillon@collabora.com \
--cc=conor.culhane@silvaco.com \
--cc=gregkh@linuxfoundation.org \
--cc=imx@lists.linux.dev \
--cc=linux-i3c@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=miquel.raynal@bootlin.com \
--cc=pthombar@cadence.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox