From: Frank Li <Frank.Li@nxp.com>
To: Alexandre Belloni <alexandre.belloni@bootlin.com>,
Boris Brezillon <boris.brezillon@collabora.com>,
Parshuram Thombare <pthombar@cadence.com>,
Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
Boris Brezillon <bbrezillon@kernel.org>,
Arnd Bergmann <arnd@arndb.de>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Conor Culhane <conor.culhane@silvaco.com>
Cc: linux-i3c@lists.infradead.org, linux-kernel@vger.kernel.org,
imx@lists.linux.dev, Frank Li <Frank.Li@nxp.com>
Subject: [PATCH v4 09/11] i3c: master: svc: use spin_lock_irqsave at svc_i3c_master_ibi_work()
Date: Thu, 29 Aug 2024 17:14:06 -0400 [thread overview]
Message-ID: <20240829-i3c_fix-v4-9-ebcbd5efceba@nxp.com> (raw)
In-Reply-To: <20240829-i3c_fix-v4-0-ebcbd5efceba@nxp.com>
According to I3C spec ver 1.1, 09-Jun-2021, section 5.1.2.5:
The I3C Controller shall hold SCL low while the Bus is in ACK/NACK Phase of
I3C/I2C transfer. But maximum stall time is 100us. The IRQs have to be
disabled to prevent schedule during the whole I3C transaction, otherwise,
the I3C bus timeout may happen if any irq or schedule happen during
transaction.
Replace mutex with spin_lock_irqsave() to avoid stalling SCL more than
100us.
Signed-off-by: Frank Li <Frank.Li@nxp.com>
---
Change from v3-v4
- improve commit message
- needn't mutex here, other place already use spin_lock_saveirq to protent
i3c transfer.
---
drivers/i3c/master/svc-i3c-master.c | 14 +++++++++++---
1 file changed, 11 insertions(+), 3 deletions(-)
diff --git a/drivers/i3c/master/svc-i3c-master.c b/drivers/i3c/master/svc-i3c-master.c
index 9f456639d1aad..2b000f446f1cc 100644
--- a/drivers/i3c/master/svc-i3c-master.c
+++ b/drivers/i3c/master/svc-i3c-master.c
@@ -432,7 +432,16 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
u32 status, val;
int ret;
- mutex_lock(&master->lock);
+ /*
+ * According to I3C spec ver 1.1, 09-Jun-2021, section 5.1.2.5:
+ *
+ * The I3C Controller shall hold SCL low while the Bus is in ACK/NACK Phase of I3C/I2C
+ * transfer. But maximum stall time is 100us. The IRQs have to be disabled to prevent
+ * schedule during the whole I3C transaction, otherwise, the I3C bus timeout may happen if
+ * any irq or schedule happen during transaction.
+ */
+ guard(spinlock_irqsave)(&master->xferqueue.lock);
+
/*
* IBIWON may be set before SVC_I3C_MCTRL_REQUEST_AUTO_IBI, causing
* readl_relaxed_poll_timeout() to return immediately. Consequently,
@@ -452,7 +461,7 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
master->regs + SVC_I3C_MCTRL);
/* Wait for IBIWON, should take approximately 100us */
- ret = readl_relaxed_poll_timeout(master->regs + SVC_I3C_MSTATUS, val,
+ ret = readl_relaxed_poll_timeout_atomic(master->regs + SVC_I3C_MSTATUS, val,
SVC_I3C_MSTATUS_IBIWON(val), 0, 1000);
if (ret) {
dev_err(master->dev, "Timeout when polling for IBIWON\n");
@@ -525,7 +534,6 @@ static void svc_i3c_master_ibi_work(struct work_struct *work)
reenable_ibis:
svc_i3c_master_enable_interrupts(master, SVC_I3C_MINT_SLVSTART);
- mutex_unlock(&master->lock);
}
static irqreturn_t svc_i3c_master_irq_handler(int irq, void *dev_id)
--
2.34.1
--
linux-i3c mailing list
linux-i3c@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-i3c
next prev parent reply other threads:[~2024-08-29 21:15 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-29 21:13 [PATCH v4 00/11] i3c: master: some fix and improvemnt for hotjoin Frank Li
2024-08-29 21:13 ` [PATCH v4 01/11] i3c: master: Remove i3c_dev_disable_ibi_locked(olddev) on device hotjoin Frank Li
2024-08-29 21:13 ` [PATCH v4 02/11] i3c: master: Replace hard code 2 with macro I3C_ADDR_SLOT_STATUS_BITS Frank Li
2024-08-29 21:14 ` [PATCH v4 03/11] i3c: master: Extend address status bit to 4 and add I3C_ADDR_SLOT_EXT_INIT Frank Li
2024-08-29 21:14 ` [PATCH v4 04/11] i3c: master: Fix dynamic address leak when 'assigned-address' is present Frank Li
2024-08-29 21:14 ` [PATCH v4 05/11] i3c: master: Fix miss free init_dyn_addr at i3c_master_put_i3c_addrs() Frank Li
2024-08-29 21:14 ` [PATCH v4 06/11] i3c: master: svc: use repeat start when IBI WIN happens Frank Li
2024-08-29 21:14 ` [PATCH v4 07/11] i3c: master: svc: manually emit NACK/ACK for hotjoin Frank Li
2024-08-29 21:14 ` [PATCH v4 08/11] i3c: master: svc: need check IBIWON for dynamtica address assign Frank Li
2024-08-29 21:14 ` Frank Li [this message]
2024-08-29 21:14 ` [PATCH v4 10/11] i3c: master: svc: wait for Manual ACK/NACK Done before next step Frank Li
2024-08-29 21:14 ` [PATCH v4 11/11] i3c: master: svc: fix possible assignment of the same address to two devices Frank Li
2024-09-26 17:02 ` [PATCH v4 00/11] i3c: master: some fix and improvemnt for hotjoin Frank Li
2024-09-30 9:34 ` Miquel Raynal
2024-09-30 15:16 ` Frank Li
2024-10-01 17:17 ` Frank Li
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240829-i3c_fix-v4-9-ebcbd5efceba@nxp.com \
--to=frank.li@nxp.com \
--cc=alexandre.belloni@bootlin.com \
--cc=arnd@arndb.de \
--cc=bbrezillon@kernel.org \
--cc=boris.brezillon@collabora.com \
--cc=conor.culhane@silvaco.com \
--cc=gregkh@linuxfoundation.org \
--cc=imx@lists.linux.dev \
--cc=linux-i3c@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=miquel.raynal@bootlin.com \
--cc=pthombar@cadence.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox