* Re: SIIMAGE sata fails with 2.6.7
[not found] ` <20040623153235.GD1010@carfax.org.uk>
@ 2004-06-23 16:35 ` George Georgalis
0 siblings, 0 replies; 2+ messages in thread
From: George Georgalis @ 2004-06-23 16:35 UTC (permalink / raw)
To: Hugo Mills, jgarzik, linux-kernel, linux-ide
On Wed, Jun 23, 2004 at 04:32:35PM +0100, Hugo Mills wrote:
>On Wed, Jun 23, 2004 at 10:16:59AM -0400, George Georgalis wrote:
>> On Tue, Jun 22, 2004 at 04:25:42PM -0400, Jeff Garzik wrote:
>> >does sata_sil driver work for you?
>>
>> I have this file,
>>
>> -rw-r--r-- 1 500 500 12779 Jun 16 01:18 ./drivers/scsi/sata_sil.c
>>
>> but I don't see a switch for it in the config, also I'm not sure where
>> the most recent patch for it is.
>
> The option is under
>
>Device Drivers --->
> SCSI device support --->
> SCSI low-level drivers --->
> [*] Serial ATA (SATA)
> < > ServerWorks Frodo / Apple K2 SATA support (EXPERIMENTAL) (NEW)
> < > Intel PIIX/ICH SATA support (NEW)
> < > Promise SATA support (NEW)
> <*> Silicon Image SATA support (NEW)
> < > VIA SATA support (NEW)
> < > VITESSE VSC-7174 SATA support (NEW)
>
Thanks, I discovered and was building that after I discovered the
"development and/or incomplete code/drivers" option is also required.
My system would not boot without SIIMAGE too, is that expected?
Should there be a dependency in menuconfig?
Sad news, at about 800 Mb, pdflush stopped completing and the device
was blocked.
Oooh, guess I needed to mount as a scsi dev now? but I don't see any
scsi devices available... must I first not mount the hdc partitions?
// George
--
George Georgalis, Architect and administrator, Linux services. IXOYE
http://galis.org/george/ cell:646-331-2027 mailto:george@galis.org
Key fingerprint = 5415 2738 61CF 6AE1 E9A7 9EF0 0186 503B 9831 1631
^ permalink raw reply [flat|nested] 2+ messages in thread