[PULL] IIO: 1st set of fixes for the 6.8 cycle.

[PULL] IIO: 1st set of fixes for the 6.8 cycle.

[Jonathan Cameron]

The following changes since commit 6613476e225e090cc9aad49be7fa504e290dd33d:

  Linux 6.8-rc1 (2024-01-21 14:11:32 -0800)

are available in the Git repository at:

  https://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-fixes-for-6.8a

for you to fetch changes up to 78367c32bebfe833cd30c855755d863a4ff3fdee:

  iio: adc: ad4130: only set GPIO_CTRL if pin is unused (2024-02-10 16:52:39 +0000)

----------------------------------------------------------------
IIO: 1st set of fixes for the 6.8 cycle

Usual mixed bag of issues introduced this cycle and fixes for long term
issues that have been identified recently + one case where I messed up
a merge resolution and dropped the build file changes.

Most important is the userspace ABI fix for the iio_modifier enum
where we accidentally added new entries in the middle rather than at
the end.

IIO Core
 - Close a memory leak in an error path.
 - Move LIGHT_UVA and LIGHT_UVB definitions to end of the iio_modifier
   enum to avoid breaking older userspace. (not yet in a released kernel
   thankfully).

adi,adis
 - Fix a DMA buffer alignment issue that was missing in series that fixed
   these across IIO.

adi,ad-sigma-delta
 - Fix a DMA buffer alignment issue that was missing in series that fixed
   these across IIO.

adi,ad4130
 - Zero init remaining fields of clock init data.
 - Only set GPIO control bits on pins that aren't in use for anything else.

adi,ad5933
 - Fix an old bug due to type mismatch. This is a rare device so good to
   get some new test coverage.

adi,ad7091r
 - Use right variable for an error return code.

bosch,bma400
 - Add missing CONFIG_REGMAP_I2C dependency.

bosch,bmp280:
 - Add missing bmp085 ID to the SPI table to avoid mismatch with the
   of_device_id table.

hid-sensors:
 - Avoid returning an error for timestamp read back that succeeds.

pni,rm3100
 - Check value read from RM31000_REG_TMRC register is valid before using
   it. Hardening  to avoid a real world issue seen on some faulty hardware.

st,st-sensors
 - Fix a DMA buffer alignment issue that was missing in series that fixed
   these across IIO.

ti,hdc3020
 - Add missing Kconfig and Makefile entrees accidentally dropped when patches
   were applied.
 - Fix wrong temperature offset (negated)

----------------------------------------------------------------
Cosmin Tanislav (2):
      iio: adc: ad4130: zero-initialize clock init data
      iio: adc: ad4130: only set GPIO_CTRL if pin is unused

Dan Carpenter (1):
      iio: adc: ad7091r8: Fix error code in ad7091r8_gpio_setup()

David Schiller (1):
      staging: iio: ad5933: fix type mismatch regression

Dimitri Fedrau (1):
      iio: humidity: hdc3020: fix temperature offset

Dinghao Liu (1):
      iio: core: fix memleak in iio_device_register_sysfs

Javier Carrasco (1):
      iio: move LIGHT_UVA and LIGHT_UVB to the end of iio_modifier

Jonathan Cameron (1):
      iio: humidity: hdc3020: Add Makefile, Kconfig and MAINTAINERS entry

Mario Limonciello (1):
      iio: accel: bma400: Fix a compilation problem

Nuno Sa (3):
      iio: imu: adis: ensure proper DMA alignment
      iio: adc: ad_sigma_delta: ensure proper DMA alignment
      iio: commom: st_sensors: ensure proper DMA alignment

Randy Dunlap (1):
      iio: imu: bno055: serdev requires REGMAP

Sam Protsenko (1):
      iio: pressure: bmp280: Add missing bmp085 to SPI id table

Srinivas Pandruvada (1):
      iio: hid-sensor-als: Return 0 for HID_USAGE_SENSOR_TIME_TIMESTAMP

zhili.liu (1):
      iio: magnetometer: rm3100: add boundary check for the value read from RM3100_REG_TMRC

 MAINTAINERS                                     |  8 ++++++++
 drivers/iio/accel/Kconfig                       |  2 ++
 drivers/iio/adc/ad4130.c                        | 12 ++++++++----
 drivers/iio/adc/ad7091r8.c                      |  2 +-
 drivers/iio/humidity/Kconfig                    | 12 ++++++++++++
 drivers/iio/humidity/Makefile                   |  1 +
 drivers/iio/humidity/hdc3020.c                  |  2 +-
 drivers/iio/imu/bno055/Kconfig                  |  1 +
 drivers/iio/industrialio-core.c                 |  5 ++++-
 drivers/iio/light/hid-sensor-als.c              |  1 +
 drivers/iio/magnetometer/rm3100-core.c          | 10 ++++++++--
 drivers/iio/pressure/bmp280-spi.c               |  1 +
 drivers/staging/iio/impedance-analyzer/ad5933.c |  2 +-
 include/linux/iio/adc/ad_sigma_delta.h          |  4 +++-
 include/linux/iio/common/st_sensors.h           |  4 ++--
 include/linux/iio/imu/adis.h                    |  3 ++-
 include/uapi/linux/iio/types.h                  |  4 ++--
 17 files changed, 58 insertions(+), 16 deletions(-)

Re: [PULL] IIO: 1st set of fixes for the 6.8 cycle.

[Greg KH]

On Sun, Feb 11, 2024 at 04:49:05PM +0000, Jonathan Cameron wrote:
> The following changes since commit 6613476e225e090cc9aad49be7fa504e290dd33d:
> 
>   Linux 6.8-rc1 (2024-01-21 14:11:32 -0800)
> 
> are available in the Git repository at:
> 
>   https://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-fixes-for-6.8a

Sorry for the delay, now queued up.

greg k-h