Re: [PATCH v2 2/2] iio: adc: ad9467: support write/read offset

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Tue, Dec 02, 2025 at 12:53:09PM +0000, Tomas Melin wrote:
> Support configuring output calibration value. Among the devices
> currently supported by this driver, this setting is specific to
> ad9434. The offset can be used to calibrate the output against
> a known input. The register is called offset, but the procedure
> is best mapped internally with calibbias operation.

...

>  static const struct iio_chan_spec ad9434_channels[] = {
> -	AD9467_CHAN(0, BIT(IIO_CHAN_INFO_SCALE), 0, 12, 's'),
> +	{
> +		.type = IIO_VOLTAGE,
> +		.indexed = 1,
> +		.channel = 0,
> +		.info_mask_shared_by_type =
> +		BIT(IIO_CHAN_INFO_SCALE) |
> +		BIT(IIO_CHAN_INFO_SAMP_FREQ) |
> +		BIT(IIO_CHAN_INFO_CALIBBIAS),

Wrong indentation.

> +		.info_mask_shared_by_type_available =
> +		BIT(IIO_CHAN_INFO_SCALE) |
> +		BIT(IIO_CHAN_INFO_CALIBBIAS),

Ditto.

> +		.scan_index = 0,
> +		.scan_type = {
> +			.sign = 's',
> +			.realbits = 12,
> +			.storagebits = 16,
> +		},
> +	},
>  };

I'm not sure about macro-less approach here, I think that we want more
consistency and hence before doing this change probably we want to clean up
the existing macro, then split it to two, and add another one here based on
the low-level, which was split in the previous clean up.

...

> +	return ad9467_spi_write(st, AN877_ADC_REG_TRANSFER,
> +				AN877_ADC_TRANSFER_SYNC);

I would make it one line, despite on being 85 characters long.
But it's up to you and maintainers.

-- 
With Best Regards,
Andy Shevchenko