Re: [PATCH v3 5/9] iio: dac: ad3552r-hs: fix message on wrong chip id

["Nuno Sá" <noname.nuno@gmail.com>]

On Fri, 2025-01-10 at 11:24 +0100, Angelo Dureghello wrote:
> From: Angelo Dureghello <adureghello@baylibre.com>
> 
> Set a better info message on wrong chip id, fixing the
> expected value as read from the info struct.
> 
> Signed-off-by: Angelo Dureghello <adureghello@baylibre.com>
> ---
>  drivers/iio/dac/ad3552r-hs.c | 5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/iio/dac/ad3552r-hs.c b/drivers/iio/dac/ad3552r-hs.c
> index 8974df625670..27949f207d42 100644
> --- a/drivers/iio/dac/ad3552r-hs.c
> +++ b/drivers/iio/dac/ad3552r-hs.c
> @@ -326,8 +326,9 @@ static int ad3552r_hs_setup(struct ad3552r_hs_state *st)
>  
>  	id |= val << 8;
>  	if (id != st->model_data->chip_id)
> -		dev_info(st->dev, "Chip ID error. Expected 0x%x, Read
> 0x%x\n",
> -			 AD3552R_ID, id);
> +		dev_info(st->dev,
> +			 "Chip ID mismatch, detected 0x%x but expected
> 0x%x\n",
> +			 id, st->model_data->chip_id);

Since you're doing this, I would prefer dev_warn() over dev_info()

- Nuno Sá

>  
>  	/* Clear reset error flag, see ad3552r manual, rev B table 38. */
>  	ret = st->data->bus_reg_write(st->back, AD3552R_REG_ADDR_ERR_STATUS,
>