[PATCH AUTOSEL 4.9 44/87] HID: intel-ish-hid: avoid binding wrong ishtp_cl_device

[PATCH AUTOSEL 4.9 44/87] HID: intel-ish-hid: avoid binding wrong ishtp_cl_device

[Sasha Levin]

From: Hong Liu <hong.liu@intel.com>

[ Upstream commit 0d28f49412405d87d3aae83da255070a46e67627 ]

When performing a warm reset in ishtp bus driver, the ishtp_cl_device
will not be removed, its fw_client still points to the already freed
ishtp_device.fw_clients array.

Later after driver finishing ishtp client enumeration, this dangling
pointer may cause driver to bind the wrong ishtp_cl_device to the new
client, causing wrong callback to be called for messages intended for
the new client.

This helps in development of firmware where frequent switching of
firmwares is required without Linux reboot.

Signed-off-by: Hong Liu <hong.liu@intel.com>
Tested-by: Hongyan Song <hongyan.song@intel.com>
Acked-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/hid/intel-ish-hid/ishtp/bus.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/hid/intel-ish-hid/ishtp/bus.c b/drivers/hid/intel-ish-hid/ishtp/bus.c
index 256521509d20..0de18c76f8d4 100644
--- a/drivers/hid/intel-ish-hid/ishtp/bus.c
+++ b/drivers/hid/intel-ish-hid/ishtp/bus.c
@@ -628,7 +628,8 @@ int ishtp_cl_device_bind(struct ishtp_cl *cl)
 	spin_lock_irqsave(&cl->dev->device_list_lock, flags);
 	list_for_each_entry(cl_device, &cl->dev->device_list,
 			device_link) {
-		if (cl_device->fw_client->client_id == cl->fw_client_id) {
+		if (cl_device->fw_client &&
+		    cl_device->fw_client->client_id == cl->fw_client_id) {
 			cl->device = cl_device;
 			rv = 0;
 			break;
@@ -688,6 +689,7 @@ void ishtp_bus_remove_all_clients(struct ishtp_device *ishtp_dev,
 	spin_lock_irqsave(&ishtp_dev->device_list_lock, flags);
 	list_for_each_entry_safe(cl_device, n, &ishtp_dev->device_list,
 				 device_link) {
+		cl_device->fw_client = NULL;
 		if (warm_reset && cl_device->reference_count)
 			continue;
 
-- 
2.19.1

[PATCH AUTOSEL 4.9 72/87] HID: intel-ish: ipc: handle PIMR before ish_wakeup also clear PISR busy_clear bit

[Sasha Levin]

From: Song Hongyan <hongyan.song@intel.com>

[ Upstream commit 2edefc056e4f0e6ec9508dd1aca2c18fa320efef ]

Host driver should handle interrupt mask register earlier than wake up ish FW
else there will be conditions when FW interrupt comes, host PIMR register still
not set ready, so move the interrupt mask setting before ish_wakeup.

Clear PISR busy_clear bit in ish_irq_handler. If not clear, there will be
conditions host driver received a busy_clear interrupt (before the busy_clear
mask bit is ready), it will return IRQ_NONE after check_generated_interrupt,
the interrupt will never be cleared, causing the DEVICE not sending following
IRQ.

Since PISR clear should not be called for the CHV device we do this change.
After the change, both ISH2HOST interrupt and busy_clear interrupt will be
considered as interrupt from ISH, busy_clear interrupt will return IRQ_HANDLED
from IPC_IS_BUSY check.

Signed-off-by: Song Hongyan <hongyan.song@intel.com>
Acked-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/hid/intel-ish-hid/ipc/ipc.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/hid/intel-ish-hid/ipc/ipc.c b/drivers/hid/intel-ish-hid/ipc/ipc.c
index 0c9ac4d5d850..41d44536aa15 100644
--- a/drivers/hid/intel-ish-hid/ipc/ipc.c
+++ b/drivers/hid/intel-ish-hid/ipc/ipc.c
@@ -92,7 +92,10 @@ static bool check_generated_interrupt(struct ishtp_device *dev)
 			IPC_INT_FROM_ISH_TO_HOST_CHV_AB(pisr_val);
 	} else {
 		pisr_val = ish_reg_read(dev, IPC_REG_PISR_BXT);
-		interrupt_generated = IPC_INT_FROM_ISH_TO_HOST_BXT(pisr_val);
+		interrupt_generated = !!pisr_val;
+		/* only busy-clear bit is RW, others are RO */
+		if (pisr_val)
+			ish_reg_write(dev, IPC_REG_PISR_BXT, pisr_val);
 	}
 
 	return interrupt_generated;
@@ -795,11 +798,11 @@ int ish_hw_start(struct ishtp_device *dev)
 {
 	ish_set_host_rdy(dev);
 
+	set_host_ready(dev);
+
 	/* After that we can enable ISH DMA operation and wakeup ISHFW */
 	ish_wakeup(dev);
 
-	set_host_ready(dev);
-
 	/* wait for FW-initiated reset flow */
 	if (!dev->recvd_hw_ready)
 		wait_event_interruptible_timeout(dev->wait_hw_ready,
-- 
2.19.1