Re: [PATCH 3/3] leds: add Realtek RTL9300 port LED driver

[sashiko-bot@kernel.org]

> The RTL9300 switch drives up to four LEDs per port over its LED
> interface, serial or scanned. Each normally shows a hardware function
> picked by the LED set of the port, but software can take it over: one
> enable bit per LED, a 3-bit mode per LED (off, on or one of six blink
> rates), kept separately for copper and fibre media, and a load strobe
> after which the LED controller applies the modes.
> 
> Add a driver for LEDs that boards wire to the switch without a hardware
> function, such as PoE status LEDs. It takes the LEDs listed in the
> device tree under software control, sets both media alike, exposes them
> as LED class devices and hands them back to their hardware function
> when it is removed. The register offsets come from the reg of its node,
> within the switch's syscon register block.
> 
> Signed-off-by: Ross Cawston <ross@r-sc.ca>

Sashiko has reviewed this patch and found no issues.

-- 
Sashiko AI review · https://sashiko.dev/#/patchset/20261018194339.132-1-ross@r-sc.ca?part=3