Re: Porting m68k/nommu to a new board.

[Greg Ungerer <gerg@snapgear.com>]

Hi Daniel,

On 19/12/11 12:24, Daniel Palmer wrote:
> Sorry for not replying sooner. Too much work :(
>
>> I run on ColdFire parts all the time. Right up to 3.2-rc5 :-)
>> It works great. But I don't have or regularly use any original m68k
>> core hardware. I occasionally compile for the 68328 target, so it
>> will compile, can't be sure if it still runs though.
>
> I did a bit of poking around, I couldn't get the 68328 target to build.. I was
> going to have a play with it in xcopilot. It complains about some linker

Yep, a couple of issues when building for the Palm/Pilot.
I just sent a couple of patches to m68k-linux that fix the main
problems. You will also want to disable CONFIG_FW_LOADER if you
have that enabled.

After that I can compile it all the way (I am building on 3.2-rc6).
No idea if it works though.

Regards
Greg



------------------------------------------------------------------------
Greg Ungerer  --  Principal Engineer        EMAIL:     gerg@snapgear.com
SnapGear Group, McAfee                      PHONE:       +61 7 3435 2888
8 Gardner Close                             FAX:         +61 7 3217 5323
Milton, QLD, 4064, Australia                WEB: http://www.SnapGear.com