cross-compiler

cross-compiler

[Chien-Lung Wu]

Hi,
I try to buils a cross-comipler in my linux box (build=i386-mips) with
host=windowNT, and target=linux-mips. But it is not successful.

I use the following tar-ball as base: (The newest one)
	a. binutils (2.11.2)
	b. gcc 3.1
	c. glibc 2.2.5

As a newbie in linux embedded system, could anyone kindly show me "HOWTO"
build up a cross-compiler in general and specifically for MIPS (IDT
R32334/32332)?

If you know any good stuffs in building cross-compiler and porting Linux to
MIPS, please send me the web-side or pointers. Thanks in advance.

Regards,

Chien-Lung

***********************************************************************
Chien-Lung Wu                                 TEL: 919-767-3903
Sr. Software Engineer                        FAX: 919-767-2458
DataCom Lab of Delta Network Inc..    e-mail: cwu@deltartp.com
***********************************************************

Re: cross-compiler

[Johannes Stezenbach]

Chien-Lung Wu wrote:
> I use the following tar-ball as base: (The newest one)
> 	a. binutils (2.11.2)
> 	b. gcc 3.1
> 	c. glibc 2.2.5
> 
> As a newbie in linux embedded system, could anyone kindly show me "HOWTO"
> build up a cross-compiler in general and specifically for MIPS (IDT
> R32334/32332)?
> 
> If you know any good stuffs in building cross-compiler and porting Linux to
> MIPS, please send me the web-side or pointers. Thanks in advance.

http://linux-mips.sourceforge.net/
http://www.junsun.net/linux/porting-howto/

HTH,
Johannes

Cross-Compiler

[Marc Karasek]

Does anyone know of any instructions/binaries for a cross-compiler
toolchain that are not based on egcs.  I am looking for one that is as
close to the current x86 as possible.  (i.e. gcc 3.x.x, binutils 2.10.x,
etc.)

Thanks,


-- 
/*************************
Marc Karasek
Sr. Firmware Engineer
iVivity Inc.
marc_karasek@ivivity.com
(770) 986-8925
(770) 986-8926 Fax
*************************/

Re: Cross-Compiler

[Jim Paris]

> Does anyone know of any instructions/binaries for a cross-compiler
> toolchain that are not based on egcs.  I am looking for one that is as
> close to the current x86 as possible.  (i.e. gcc 3.x.x, binutils 2.10.x,
> etc.)

http://www.ltc.com/~brad/mips/mipsel-linux-cross-toolchain-building.txt

-jim