Re: [PATCH 3/4] RFC: Add BCM947XX to Kconfig

[Andrew Morton <akpm@linux-foundation.org>]

On Thu, 9 Aug 2007 02:45:14 +0200
Aurelien Jarno <aurelien@aurel32.net> wrote:

> The patch below against 2.6.23-rc1-mm2 adds a BCM947XX option to 
> Kconfig.
> 
> Cc: Michael Buesch <mb@bu3sch.de>
> Cc: Felix Fietkau <nbd@openwrt.org>
> Cc: Florian Schirmer <jolt@tuxbox.org>
> Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
> 
> --- a/arch/mips/Kconfig
> +++ b/arch/mips/Kconfig
> @@ -67,6 +67,20 @@
>  	  note that a kernel built with this option selected will not be
>  	  able to run on normal units.
>  
> +config BCM947XX
> +	bool "BCM947xx based boards"
> +	select DMA_NONCOHERENT
> +	select HW_HAS_PCI
> +	select IRQ_CPU
> +	select SYS_HAS_CPU_MIPS32_R1
> +	select SYS_SUPPORTS_32BIT_KERNEL
> +	select SYS_SUPPORTS_LITTLE_ENDIAN
> +	select SSB
> +	select SSB_DRIVER_MIPS
> +	select GENERIC_GPIO
> +	help
> +	 Support for BCM947xx based boards
> +
>  config MIPS_COBALT
>  	bool "Cobalt Server"
>  	select DMA_NONCOHERENT
> --- a/drivers/ssb/Kconfig
> +++ b/drivers/ssb/Kconfig
> @@ -67,6 +67,7 @@
>  config SSB_PCICORE_HOSTMODE
>  	bool "Hostmode support for SSB PCI core"
>  	depends on SSB_DRIVER_PCICORE && SSB_DRIVER_MIPS
> +	default y if BCM947XX
>  	help
>  	  PCIcore hostmode operation (external PCI bus).

I'll consider these to be MIPS patches, so I'll spam Ralf with them.

I dropped the second hunk here, as Ralf has no drivers/ssb.  This will
need to be wired up in some later patch, once these various trees all end
up in the same place, presumably Linus's tree.