Re: mips32_flush_cache routine corrupts CP0_STATUS with gcc-2.96

[Carsten Langgaard <carstenl@mips.com>]

"Gleb O. Raiko" wrote:

> Ralf Baechle wrote:
> >
> > On Wed, Jul 10, 2002 at 03:16:21PM +0100, Jon Burgess wrote:
> >
> > > This may be caused by the cache routines running from the a cached kseg0, it
> > > looks like it can be fixed by making sure that the are always called via
> > > KSEG1ADDR(fn) which looks like it could be done with a bit of fiddling of the
> > > setup_cache_funcs code. I have included a patch below which starts this, but I
> > > haven't caught all combinations of how the routines are called.
> >
> > While that could be done it's not a good idea; running code in KSEG1 is
> > very slow.
> >
>
> Unfortunately, it's required by manuals for some processors. As I know,
> IDT HW manuals clearly state cache flush routines must operate from
> uncached code and must access uncached data only. Examples are R30x1 CPU
> series.

Yes, that's true.
But that code belongs in the R30xx specific cache routines, not in the MIPS32 cache
routines.

>
> Regards,
> Gleb.

--
_    _ ____  ___   Carsten Langgaard   Mailto:carstenl@mips.com
|\  /|||___)(___   MIPS Denmark        Direct: +45 4486 5527
| \/ |||    ____)  Lautrupvang 4B      Switch: +45 4486 5555
  TECHNOLOGIES     2750 Ballerup       Fax...: +45 4486 5556
                   Denmark             http://www.mips.com