From: Chaotian Jing <chaotian.jing@mediatek.com>
To: NeilBrown <neil@brown.name>
Cc: Ulf Hansson <ulf.hansson@linaro.org>,
linux-mmc@vger.kernel.org, linux-kernel@vger.kernel.org,
thirtythreeforty@gmail.com
Subject: Re: [PATCH 4/5] mmc: mtk-sd: enable internal card-detect logic.
Date: Thu, 18 Apr 2019 14:39:43 +0800 [thread overview]
Message-ID: <1555569583.18628.29.camel@mhfsdcap03> (raw)
In-Reply-To: <155539004931.25108.17076624786044710325.stgit@noble.brown>
On Tue, 2019-04-16 at 14:47 +1000, NeilBrown wrote:
> The mtk-sd silicon has integrated card-detect logic that is
> enabled, at least, on the MT7621 as used in the GNUBEE NAS.
>
> If the sdhci isn't marked non-removable and doesn't have a
> cd-gpio configured, assume the internal cd logic should be used.
>
> Signed-off-by: NeilBrown <neil@brown.name>
> ---
> drivers/mmc/host/mtk-sd.c | 58 ++++++++++++++++++++++++++++++++++++++++++---
> 1 file changed, 54 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
> index d379f2ece305..341cf5f03429 100644
> --- a/drivers/mmc/host/mtk-sd.c
> +++ b/drivers/mmc/host/mtk-sd.c
> @@ -300,6 +300,8 @@
> #define CMD_TIMEOUT (HZ/10 * 5) /* 100ms x5 */
> #define DAT_TIMEOUT (HZ * 5) /* 1000ms x5 */
>
> +#define DEFAULT_DEBOUNCE (8) /* 8 cycles CD debounce */
> +
> #define PAD_DELAY_MAX 32 /* PAD delay cells */
> /*--------------------------------------------------------------------------*/
> /* Descriptor Structure */
> @@ -430,6 +432,7 @@ struct msdc_host {
> bool hs400_cmd_resp_sel_rising;
> /* cmd response sample selection for HS400 */
> bool hs400_mode; /* current eMMC will run at hs400 mode */
> + bool internal_cd; /* Use internal card-detect logic */
> struct msdc_save_para save_para; /* used when gate HCLK */
> struct msdc_tune_para def_tune_para; /* default tune setting */
> struct msdc_tune_para saved_tune_para; /* tune result of CMD21/CMD19 */
> @@ -1430,6 +1433,11 @@ static irqreturn_t msdc_irq(int irq, void *dev_id)
> sdio_signal_irq(host->mmc);
> }
>
> + if ((events & event_mask) & MSDC_INT_CDSC) {
> + mmc_detect_change(host->mmc, msecs_to_jiffies(20));
> + events &= ~MSDC_INT_CDSC;
> + }
> +
> if (!(events & (event_mask & ~MSDC_INT_SDIOIRQ)))
> break;
>
> @@ -1463,14 +1471,24 @@ static void msdc_init_hw(struct msdc_host *host)
> /* Reset */
> msdc_reset_hw(host);
>
> - /* Disable card detection */
> - sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> -
> /* Disable and clear all interrupts */
> writel(0, host->base + MSDC_INTEN);
> val = readl(host->base + MSDC_INT);
> writel(val, host->base + MSDC_INT);
>
> + /* Configure card detection */
> + if (host->internal_cd) {
> + sdr_set_field(host->base + MSDC_PS, MSDC_PS_CDDEBOUNCE,
> + DEFAULT_DEBOUNCE);
> + sdr_set_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> + sdr_set_bits(host->base + MSDC_INTEN, MSDC_INTEN_CDSC);
> + sdr_set_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> + } else {
> + sdr_clr_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> + sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> + sdr_clr_bits(host->base + MSDC_INTEN, MSDC_INTEN_CDSC);
> + }
> +
> if (host->top_base) {
> writel(0, host->top_base + EMMC_TOP_CONTROL);
> writel(0, host->top_base + EMMC_TOP_CMD);
> @@ -1580,6 +1598,11 @@ static void msdc_init_hw(struct msdc_host *host)
> static void msdc_deinit_hw(struct msdc_host *host)
> {
> u32 val;
> +
> + /* Disabled card-detect */
> + sdr_clr_bits(host->base + MSDC_PS, MSDC_PS_CDEN);
> + sdr_clr_bits(host->base + SDC_CFG, SDC_CFG_INSWKUP);
> +
> /* Disable and clear all interrupts */
> writel(0, host->base + MSDC_INTEN);
>
> @@ -2078,13 +2101,31 @@ static void msdc_ack_sdio_irq(struct mmc_host *mmc)
> __msdc_enable_sdio_irq(mmc, 1);
> }
>
> +static int msdc_get_cd(struct mmc_host *mmc)
> +{
> + struct msdc_host *host = mmc_priv(mmc);
> + int val;
> +
> + if (mmc->caps & MMC_CAP_NONREMOVABLE)
> + return 1;
> +
> + if (!host->internal_cd)
> + return mmc_gpio_get_cd(mmc);
> +
> + val = readl(host->base + MSDC_PS) & MSDC_PS_CDSTS;
> + if (mmc->caps2 & MMC_CAP2_CD_ACTIVE_HIGH)
> + return !!val;
> + else
> + return !val;
> +}
> +
> static const struct mmc_host_ops mt_msdc_ops = {
> .post_req = msdc_post_req,
> .pre_req = msdc_pre_req,
> .request = msdc_ops_request,
> .set_ios = msdc_ops_set_ios,
> .get_ro = mmc_gpio_get_ro,
> - .get_cd = mmc_gpio_get_cd,
> + .get_cd = msdc_get_cd,
> .enable_sdio_irq = msdc_enable_sdio_irq,
> .ack_sdio_irq = msdc_ack_sdio_irq,
> .start_signal_voltage_switch = msdc_ops_switch_volt,
> @@ -2206,6 +2247,15 @@ static int msdc_drv_probe(struct platform_device *pdev)
> goto host_free;
> }
>
> + if (!(mmc->caps & MMC_CAP_NONREMOVABLE) &&
> + !mmc_can_gpio_cd(mmc)) {
Should not do this assume!
better to add "mediatek,internal-cd" in your DTS, then no impact to
other Soc.
> + /*
> + * Is removable but no GPIO declared, so
> + * use internal functionality.
> + */
> + host->internal_cd = true;
> + }
> +
> msdc_of_property_parse(pdev, host);
>
> host->dev = &pdev->dev;
>
>
next prev parent reply other threads:[~2019-04-18 6:39 UTC|newest]
Thread overview: 11+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-04-16 4:47 [PATCH 0/5] mtk-sd enhancement to support MT7621 NeilBrown
2019-04-16 4:47 ` [PATCH 3/5] mmc: mtk-sd: add support for config found in mt7620 family SOCs NeilBrown
2019-04-16 4:47 ` [PATCH 2/5] mmc: mtk-sd: don't hard-code interrupt trigger type NeilBrown
2019-04-16 8:11 ` Chaotian Jing
2019-04-16 22:12 ` NeilBrown
2019-04-18 6:36 ` Chaotian Jing
2019-04-16 4:47 ` [PATCH 1/5] mmc: mtk-sd: support "voltage-ranges" setting NeilBrown
2019-04-16 4:47 ` [PATCH 5/5] mmc: mtk-sd: enable internal write-protect logic NeilBrown
2019-04-16 4:47 ` [PATCH 4/5] mmc: mtk-sd: enable internal card-detect logic NeilBrown
2019-04-18 6:39 ` Chaotian Jing [this message]
2019-05-04 8:18 ` NeilBrown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1555569583.18628.29.camel@mhfsdcap03 \
--to=chaotian.jing@mediatek.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=neil@brown.name \
--cc=thirtythreeforty@gmail.com \
--cc=ulf.hansson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox