* Re: [PATCH 2/2] arm64: dts: h3ulcb: enable HS200 for eMMC
[not found] ` <1485443640-22651-1-git-send-email-vladimir.barinov@cogentembedded.com>
@ 2017-01-27 8:29 ` Simon Horman
0 siblings, 0 replies; only message in thread
From: Simon Horman @ 2017-01-27 8:29 UTC (permalink / raw)
To: Vladimir Barinov
Cc: Magnus Damm, Rob Herring, Mark Rutland, devicetree,
linux-renesas-soc, Wolfram Sang, linux-mmc
[CC Wolfram, linux-mmc]
On Thu, Jan 26, 2017 at 06:14:00PM +0300, Vladimir Barinov wrote:
> From: Vladimir Barinov <vladimir.barinov+renesas@cogentembedded.com>
>
> This supports HS200 mode for eMMC on H3ULCB board
>
> Signed-off-by: Vladimir Barinov <vladimir.barinov+renesas@cogentembedded.com>
Hi Vladimir,
Please resend this change once the relevant driver changes hit an rc
release.
I believe that means the following changes which are present in mmc/next.
8c81459fa8ad mmc: sh_mobile_sdhi: enable HS200
60f215caef3f mmc: sh_mobile_sdhi: remove superfluous check in SCC error check
f7c68068fb27 mmc: sh_mobile_sdhi: remove superfluous check in init_tuning
4cf3ecd2e097 mmc: sh_mobile_sdhi: remove superfluous check in hw_reset
bdba200138a9 mmc: sh_mobile_sdhi: improve prerequisites for tuning
a7f2c661cca9 mmc: sh_mobile_sdhi: improve prerequisite for hw_reset
59c21074b582 mmc: sh_mobile_sdhi: simplify accessing DT data
^ permalink raw reply [flat|nested] only message in thread