[PATCH v6 0/3] mtd: spi-nor: Add support for Cypress s25hl-t/s25hs-t

From: tkuw584924@gmail.com
To: linux-mtd@lists.infradead.org
Cc: tudor.ambarus@microchip.com, miquel.raynal@bootlin.com,
	richard@nod.at, vigneshr@ti.com, p.yadav@ti.com,
	Bacem.Daassi@infineon.com,
	Takahiro Kuwano <Takahiro.Kuwano@infineon.com>
Subject: [PATCH v6 0/3] mtd: spi-nor: Add support for Cypress s25hl-t/s25hs-t
Date: Wed, 16 Jun 2021 17:44:52 +0900	[thread overview]
Message-ID: <cover.1623831222.git.Takahiro.Kuwano@infineon.com> (raw)

From: Takahiro Kuwano <Takahiro.Kuwano@infineon.com>

The S25HL-T/S25HS-T family is the Cypress Semper Flash with Quad SPI.

The summary datasheets can be found in the following links.
https://www.cypress.com/file/424146/download (256Mb/512Mb/1Gb, single die)

The full version can be found in the following links (registration
required).
https://community.cypress.com/t5/Semper-Flash-Access-Program/Datasheet-Semper-Flash-with-Quad-SPI/ta-p/260789?attachment-id=19522

Tested on Xilinx Zynq-7000 FPGA board.

Changes in v6:
  - Remove 2Gb dual die package parts and related changes to split mulit
    die package support into another series of patches  

Changes in v5:
  - Fix 'if (ret == 1)' to 'if (ret < 0)' in spansion_read_any_reg()
  - Add NO_CHIP_ERASE flag to S25HL02GT and S25HS02GT

Changes in v4:
  - Reword 'legacy' to 'default'
  - Rename spi_nor_read() to spi_nor_default_ready()
  - Fix dummy cycle calculation in spansion_read_any_reg()
  - Modify comment for spansion_write_any_reg()
  - Merge block comments about SMPT in s25hx_t_post_sfdp_fixups()
  - Remove USE_CLSR flags from S25HL02GT and S25HS02GT

Changes in v3:
  - Split into multiple patches
  - Remove S25HL256T and S25HS256T
  - Add S25HL02GT and S25HS02GT 
  - Add support for multi-die package parts support
  - Cleanup Read/Write Any Register implementation
  - Remove erase_map fix for top/split sector layout
  - Set ECC data unit size (16B) to writesize 

Changes in v2:
  - Remove SPI_NOR_SKIP_SFDP flag and clean up related fixups
  - Check CFR3V[4] to determine page_size instead of force 512B
  - Depend on the patchset below to support non-uniform sector layout
    https://lore.kernel.org/linux-mtd/cover.1601612872.git.Takahiro.Kuwano@infineon.com/

Takahiro Kuwano (3):
  mtd: spi-nor: spansion: Add support for Read/Write Any Register
  mtd: spi-nor: spansion: Add support for volatile QE bit
  mtd: spi-nor: spansion: Add s25hl-t/s25hs-t IDs and fixups

 drivers/mtd/spi-nor/spansion.c | 278 +++++++++++++++++++++++++++++++++
 1 file changed, 278 insertions(+)

-- 
2.25.1

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/